TE0701 TRM

v.66

Copyright ©  2018 Trenz Electronic GmbH

6 of 22

http://www.trenz-electronic.de

2.2 Main Components

Figure 2: 4 x 5 SoM carrier board TE0701-06.

1. HDMI connector (1.4 HEAC support)

2. Micro-USB connector (device, host or OTG modes)

3. Pmod connector for access to Zynq module's PL IO-bank pins (4 LVDS pairs, max. VCCIO voltage: VIOTA)

4. Pmod connector for access to Zynq module's PL IO-bank pins (4 LVDS pairs, max. VCCIO voltage: FMC_VADJ)

5. User push-button S2 ("RESTART" button by default)

6. User push-button S1 ("RESET" button by default)

7. User LEDs (function mapping depends on firmware of System Controller CPLD)

8. Mini-USB connector (USB JTAG and UART interface)

9. User 4-bit DIP switch

10. VITA 57.1 compliant FMC LPC connector with digitally programmable FMC VADJ power supply

11. Barrel jack for 12V power supply

12. ARM JTAG connector (DS-5 D-Stream) - PJTAG to EMIO multiplexing needed

13. User 4-bit DIP switch (to adjust voltage of FMC_VADJ)

14. Pmod connector (J1, max. VCCIO voltage: 3.3V): mapped to 8 Zynq PS MIO0 bank pins (MIO0, MIO9 to

MIO15), 6 pins (MIO10 to MIO15) are additionally connected to TE0701 System Controller CPLD

15. RJ45 Gigabit Ethernet connector

16. SD Card connector, Zynq SDIO0 controller, can be used to boot system

17. Pmod connector (J2, max. VCCIO voltage: 3.3V): 6 pins (PX0 to PX5) can be multiplexed by Texas Instruments

TXS02612RTWR SDIO Port Expander to MIO pins of Zynq module, 2 pins are connected to TE0701 System

Controller CPLD (PX6 and PX7)

18. Jumper J18

19. Mini Camera Link connector

20. Battery holder for CR1220 (RTC backup voltage)

21. Trenz Electronic 4 x 5 modules high-speed connector strips (3x Samtec LSHM series connectors)

22. Jumper J16, J17, J21