CFA633-RDI-KS datasheet(25/88 Pages) CRYSTAIFONTZ

номер детали	CFA633-RDI-KS

подробное описание детали	INTELLIGENT LCD MODULE

PDF	88 Pages

Scroll/Zoom	100%

производитель	CRYSTAIFONTZ [Crystalfontz America, Inc.]

домашняя страница	https://www.crystalfontz.com/

Logo

25 / 88 page

Crystalfontz America, Inc.

Data Sheet Release Date 2012/02/21

www.crystalfontz.com

CFA633-RDI-KS LCD Module (Hardware v2.0 / Firmware s2v1)

February 2012

Page 25

CONNECTION INFORMATION

STANDARD POWER CONNECTION

The easiest way to provide power from a host to CFA633-RDI-KS is to connect a cable that would normally be used from

the host’s power supply to a peripheral. If an older PC is the host, this would be the cable for the 3.5-inch floppy drive

connection. If a cable is not available, you may buy the Crystalfontz WR-PWR-Y12 cable to connect to the large 4-pin

power supply cable connector.

JP7 and JP8 are closed by default. JP7 can be opened to supply power to the fans separate from the power to the

backlight. See Jumper Locations and Functions (All Interfaces) (Pg. 17).

The connector loaded at J_PWR is (Tyco Electronics / Amp part number 4-171825-4, Mouser Electronics part number

571-4-171825-4).

Figure 8. Standard Power Supply Connection through J_PWR

NOTE

Do not connect high power fans to the module when +12v is supplied through J8, Pin 3 and JP7 is

closed. Total fan current must be less than 500 mA if +12v is supplied through J8, Pin 3 and JP7 is

closed. When using high power fans, supply the +12v through the J_PWR connector.

JP7

TACH

GND

PWR

FAN3

FAN4

TACH

GND

PWR

FONTZ

FA-633

v2.0

JP8

J_PWR

CFA633-RDI-KS датащи(PDF) 25 Page - Crystalfontz America, Inc.