PIC12F635ESLASHP datasheet(62/196 Pages) MICROCHIP

62 / 196 page

PIC12F635/PIC16F636/639

DS41232B-page 60

Preliminary

6.5

Timer1 Operation in

Asynchronous Counter Mode

If control bit T1SYNC (T1CON<2>) is set, the external

clock input is not synchronized. The timer continues to

increment asynchronous to the internal phase clocks.

The timer will continue to run during Sleep and can

generate an interrupt on overflow, which will wake-up the

processor. However, special precautions in software are

needed to read/write the timer (see Section 6.5.1

“Reading and Writing Timer1 in Asynchronous

Counter Mode”).

6.5.1

READING AND WRITING TIMER1 IN

ASYNCHRONOUS COUNTER

MODE

Reading TMR1H or TMR1L while the timer is running

from an external asynchronous clock will ensure a valid

read (taken care of in hardware). However, the user

should keep in mind that reading the 16-bit timer in two

8-bit values itself, poses certain problems, since the

timer may overflow between the reads.

For writes, it is recommended that the user simply stop

the timer and write the desired values. A write

contention may occur by writing to the timer registers

while the register is incrementing. This may produce an

unpredictable value in the timer register.

Reading

the

16-bit

value

requires

some

care.

Examples in the “PICmicro® Mid-Range MCU Family

Reference Manual” (DS33023) show how to read and

write Timer1 when it is running in Asynchronous mode.

6.6

Timer1 Oscillator

A crystal oscillator circuit is built-in between pins OSC1

(input) and OSC2 (amplifier output). It is enabled by

setting control bit, T1OSCEN (T1CON<3>). The

oscillator is a low-power oscillator rated up to 31 kHz. It

will continue to run during Sleep. It is primarily intended

for a 32 kHz crystal. Table 3-1 shows the capacitor

selection for the Timer1 oscillator.

The Timer1 oscillator is shared with the system LP

oscillator. Thus, Timer1 can use this mode only when

the primary system clock is derived from the internal

oscillator. As with the system LP oscillator, the user

must provide a software time delay to ensure proper

oscillator start-up.

TRISA5 and TRISA4 bits are set when the Timer1

oscillator is enabled. RA5 and RA4 bits read as ‘0’ and

TRISA5 and TRISA4 bits read as ‘1’.

6.7

Timer1 Operation During Sleep

Timer1 can only operate during Sleep when set up in

Asynchronous Counter mode. In this mode, an external

crystal or clock source can be used to increment the

counter. To set up the timer to wake the device:

• Timer1 must be on (T1CON<0>)

• TMR1IE bit (PIE1<0>) must be set

• PEIE bit (INTCON<6>) must be set

The device will wake-up on an overflow. If the GIE bit

(INTCON<7>) is set, the device will wake-up and jump

to the Interrupt Service Routine (0004h) on an overflow.

If the GIE bit is clear, execution will continue with the

next instruction.

TABLE 6-1:

REGISTERS ASSOCIATED WITH TIMER1

Note:

The CMCON0 (19h) register must be

initialized to configure an analog channel

as a digital input. Pins configured as

analog inputs will read ‘0’.

Note:

The oscillator requires a start-up and

stabilization

time

before

use.

Thus,

T1OSCEN should be set and a suitable

delay observed prior to enabling Timer1.

Addr

Name

Bit 7

Bit 6

Bit 5

Bit 4

Bit 3

Bit 2

Bit 1

Bit 0

Value on

POR, BOD,

WUR

Value on

all other

Resets

0Bh/

8Bh

INTCON

GIE

PEIE

T0IE

INTE

RAIE

T0IF

INTF

RAIF

0000 0000 0000 0000

0Ch

PIR1

EEIF

LVDIF

CRIF

C2IF

C1IF

OSFIF

—TMR1IF 0000 00-0 0000 00-0

0Eh

TMR1L

Holding Register for the Least Significant Byte of the 16-bit TMR1 Register

xxxx xxxx uuuu uuuu

0Fh

TMR1H

Holding Register for the Most Significant Byte of the 16-bit TMR1 Register

xxxx xxxx uuuu uuuu

10h

T1CON

T1GINV TMR1GE T1CKPS1 T1CKPS0 T1OSCEN T1SYNC TMR1CS TMR1ON 0000 0000 uuuu uuuu

1Ah

CMCON

—

—T1GSS

C2SYNC ---- --10 ---- --10

8Ch

PIE1

EEIE

LVDIE

CRIE

C2IE

C1IE

OSFIE

—TMR1IE 0000 00-0 0000 00-0

Legend:

= unknown, u = unchanged, — = unimplemented, read as ‘0’. Shaded cells are not used by the Timer1 module.

PIC12F635E/P датащи(PDF) 62 Page - Microchip Technology

PIC12F635E/P датащи(HTML) 62 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL