RF96 datasheet(66/121 Pages) HOPE

66 / 121 page

Page 66

RF96/97/98

Tel: +86-755-82973805

Fax: +86-755-82973550

E-mail: sales@hoperf.com http://www.hoperf.com

WIRELESS & SENSING

PRELIMINARY

DATASHEET

4.2.12.3. Rx Processing

If the bit synchronizer is disabled, the raw demodulator output is made directly available on DATA pin and no DCLK signal

is provided.

Conversely, if the bit synchronizer is enabled, synchronous cleaned data and clock are made available respectively on

DIO2/DATA and DIO1/DCLK pins. DATA is sampled on the rising edge of DCLK and updated on the falling edge as

illustrated below.

DATA (NRZ)

DCLK

Figure 31. Rx Processing in Continuous Mode

Note

In Continuous mode it is always recommended to enable the bit synchronizer to clean the DATA signal even if the

DCLK signal is not used by the uC (bit synchronizer is automatically enabled in Packet mode).

4.2.13. Packet Mode

4.2.13.1. General Description

In Packet mode the NRZ data to (from) the (de)modulator is not directly accessed by the uC but stored in the FIFO and

accessed via the SPI interface.

In addition, the RF96/97/98 packet handler performs several packet oriented tasks such as Preamble and Sync word

generation, CRC calculation/check, whitening/dewhitening of data, Manchester encoding/decoding, address filtering, etc.

This simplifies software and reduces uC overhead by performing these repetitive tasks within the RF chip itself.

Another important feature is ability to fill and empty the FIFO in Sleep/Stdby mode, ensuring optimum power consumption

and adding more flexibility for the software.

RF96 датащи(PDF) 66 Page - HOPE Microelectronics CO., Ltd.