STANDARD

MICROCIRCUIT DRAWING

SIZE

A

5962-99612

DLA LAND AND MARITIME

COLUMBUS, OHIO 43218-3990

REVISION LEVEL

B

SHEET

5

DSCC FORM 2234

APR 97

3.7 Certificate of compliance. A certificate of compliance shall be required from a manufacturer in order to supply to this

drawing. The certificate of compliance (original copy) submitted to DLA Land and Maritime -VA shall affirm that the

manufacturer's product meets the performance requirements of MIL-PRF-38534 and herein.

3.8 Certificate of conformance. A certificate of conformance as required in MIL-PRF-38534 shall be provided with each lot of

microcircuits delivered to this drawing.

4. VERIFICATION

4.1 Sampling and inspection. Sampling and inspection procedures shall be in accordance with MIL-PRF-38534 or as

modified in the device manufacturer's Quality Management (QM) plan. The modification in the QM plan shall not affect the form,

fit, or function as described herein.

4.2 Screening. Screening shall be in accordance with MIL-PRF-38534. The following additional criteria shall apply:

a.

Burn-in test, method 1015 of MIL-STD-883.

(1)

Test condition A, B, C, or D. The test circuit shall be maintained by the manufacturer under document revision level

control and shall be made available to either DLA Land and Maritime -VA or the acquiring activity upon request.

Also, the test circuit shall specify the inputs, outputs, biases, and power dissipation, as applicable, in accordance

with the intent specified in test method 1015 of MIL-STD-883.

(2)

b.

Interim and final electrical test parameters shall be as specified in table II herein, except interim electrical parameter

tests prior to burn-in are optional at the discretion of the manufacturer.

4.3 Conformance and periodic inspections. Conformance inspection (CI) and periodic inspection (PI) shall be in accordance

with MIL-PRF-38534 and as specified herein.

4.3.1 Group A inspection (CI). Group A inspection shall be in accordance with MIL-PRF-38534 and as follows:

a.

Tests shall be as specified in table II herein.

b.

Subgroups 7, 8, 9, 10, and 11 shall be omitted.

4.3.2 Group B inspection (PI). Group B inspection shall be in accordance with MIL-PRF-38534.

4.3.3 Group C inspection (PI). Group C inspection shall be in accordance with MIL-PRF-38534 and as follows:

a.

End-point electrical parameters shall be as specified in table II herein.

b.

Steady-state life test, method 1005 of MIL-STD-883.

(1)

Test condition A, B, C, or D. The test circuit shall be maintained by the manufacturer under document revision level

control and shall be made available to either DLA Land and Maritime -VA or the acquiring activity upon request.

Also, the test circuit shall specify the inputs, outputs, biases, and power dissipation, as applicable, in accordance

with the intent specified in method 1005 of MIL-STD-883.

(2)

(3)

Test duration: 1,000 hours, except as permitted by method 1005 of MIL-STD-883.

4.3.4 Group D inspection (PI). Group D inspection shall be in accordance with MIL-PRF-38534.