MAS6510 datasheet(12/32 Pages) MAS

12 / 32 page

DA6510.009

6 September, 2018

12 (32)

MEASUREMENT CONTROL REGISTER (E2/62HEX)

This register is used to configure and initiate a

measurement. See table 3 below. A new conversion

is started simply by writing 8-bit configuration data

having SCO=1 to the measurement control register

(E2/62HEX).

Table 3. Measurement control register (E2/62HEX) description

Bit Number

Bit Name

Description

Value

Function

7-5

OSRS

Over Sampling Ratio

(OSR) Selection

000

001

010

011

100

OSR = 256

OSR = 512

OSR = 1024

OSR = 2048

OSR = 4096

TEMPREGEN

Temperature Mode

Regulator Enable

Voltage regulator disabled

Voltage regulator enabled

SCO

Start Conversion

No conversion

Start conversion

2-1

SEL

Capacitive/ VDD

Monitoring /

Temperature Selection

External capacitive sensor

VDD level monitoring

Internal temperature sensor

XRC

Front end function

selector

Ratio converter

Difference converter

The OSRS over sampling ratio selection bits choose

between five different OSR values. High OSR value

corresponds to high resolution but also longer

conversion

time.

See

ELECTRICAL

CHARACTERISTICS for further details.

The TEMPREGEN bit enables/disables the internal

temperature mode voltage regulator. Regulator must

enabled

(TEMPREGEN=1)

temperature

measurement (SEL=10) but it should be disabled

(TEMPREGEN=0)

capacitance

and

VDD

monitoring modes. When enabled the regulator is

turned on during conversions and automatically

turned off after each conversion to save power. Note

also that if in Test register FOSC=1 and if

TEMPREGEN=1 the regulator is forced on all the

time even when measurement is not running.

The SCO Start conversion bit needs to be set 1 for

every new measurement. It is automatically reset to

0 after each measurement.

The SEL sensor selection bits control the front-end

multiplexer. It connects either the external capacitive

sensor (SEL=00), VDD level monitoring voltage

(SEL=01)

the

internal

temperature

sensor

(SEL=10) to the

-converter.

The XRC bit selects between two external capacitive

sensor measurement modes. The XRC bit selection

does not have any effect on temperature or VDD

level monitoring measurements. In Ratio converter

mode the output will be proportional to capacitance

ratio (CS-CR)/CS. In Difference converter mode the

output will be proportional to capacitance difference

(CS-CR).

MAS6510 датащи(PDF) 12 Page - Micro Analog systems

MAS6510 датащи(HTML) 12 Page - Micro Analog systems

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32

датащи скачать

ссылки URL