16

ATSAM3303

6091A–DRMSD–07/04

Serial Slave

Synchronous Interface

The ATSAM3303 can be controlled by an external host processor through the unidirec-

tional serial interface. However, no firmware can be downloaded at power-up through

this interface. Therefore an external ROM/Flash/EEPROM is required.

Pins used: SCLK, SYNC, SDIN (input), INT (output)

Data is shifted MSB first. The IC samples an incoming SDIN bit on the rising edge of

SCLK, therefore the host should change SDIN on the negative SCLK edge.

SYNC allows initial synchronization. The rising edge of SYNC, which should occur with

SCLK low, indicates that SDIN will hold MSB data on the next rising SCLK.

The data is stored internally in a 256-byte FIFO.

When the FIFO count is below 64, the INT output goes low. This allows the host proces-

sor to send data in burst mode.

The maximum SCLK frequency is fck (fck being the crystal frequency).

The minimum time between two bytes is 64 fck periods.

The contents of the SDIN data are defined by the firmware.

Figure 8. Serial Slave Interface Typical Timing

Digital Audio

Pins used: CLBD (output), WSBD (output), DABD3 - 0 (outputs), DAAD3 - 0 (inputs)

Optionally: CLAD3 - 0 (inputs), WSAD3 - 0 (inputs)

The ATSAM3303 allows for 8 digital audio output channels and 8 digital audio input

channels. All audio channels are normally synchronized on single clocks CLBD, WSBD

which are derived from the IC crystal oscillator. However, as a firmware option, the

DAAD3 - 0 inputs can be synchronized with incoming CLAD3 - 0 and WSAD3 - 0 sig-

nals. In this case, the incoming sampling frequencies must be lower or equal to the chip

sampling frequency.

The digital audio timing follows the I2S standard, with up to 24 bits per sample

MSB

SCLK

SYNC

SDIN