ATSAM3303 datasheet(9/25 Pages) ATMEL

9 / 25 page

ATSAM3303

6091A–DRMSD–07/04

P1.15

I/O

General-purpose I/O pin. This pin has built-in pull-up. It may be left

open if not used.

X1 - X2

72, 71

External crystal connection. Standard frequencies are 6.9552 MHz, 9.6

MHz, 11.2896 MHz, 12.288 MHz. Max frequency is 12.5 MHz. An

external clock (max. 1.8V

PP) can be connected to X1 using AC coupling

(22 pF). A built-in PLL multiplies the clock frequency by 4 for internal

use.

LFT

PLL decoupling RCR filter

RESET

Master reset Schmitt trigger input, active low. RESET should be held

low during at least 5ms after power is applied. On the rising edge of

RESET, the chip enters an initialization routine, which may involve

firmware download from an external SmartMedia, DataFlash or host.

STIN

Serial test input. This is a 57.6 Kbaud asynchronous input used for

firmware debugging. This pin is tested at power-up. The built-in

debugger starts if STIN is found high. STIN has a built-in pull-down. It

should be grounded or left open for normal operation.

STOUT

Out

Serial test output. 57.6 Kbaud async output used for firmware

debugging.

PDWN

Power down input, active low. High level on this pin is typ. VC18. When

PDWN is low, the oscillator and PLL are stopped, the power switch

opens, and the chip enters a deep sleep mode (1 µA typ. consumption

when power switch is used). To exit from power down, PDWN has to be

set high then RESET applied. Alternate programmable power-downs

are available which allow warm restart of the chip.

TEST

Test input. Should be grounded or left open.

Table 2. Pinout by Pin Name

Pin Name

Pin Number

Type

Sharing

Description

ATSAM3303 датащи(PDF) 9 Page - ATMEL Corporation

ATSAM3303 датащи(HTML) 9 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25

датащи скачать

ссылки URL