Rev. 1.0
12
NOTES:
1. TAS is measured from the address valid to the beginning of write.
2. The internal write time of the memory is defined by the overlap of /CE1 and CE2 active and /WE
low. All signals must be active to initiate a write and any one signal can terminate a write by going
inactive. The data input setup and hold timing should be referenced to the second transition edge
of the signal that terminates the write.
3. TWR is measured from the earlier of /CE1 or /WE going high or CE2 going low at the end of write
cycle.
4. During this period, DQ pins are in the output state so that the input signals of opposite phase to
the outputs must not be applied.
5. If the /CE1 low transition or CE2 high transition occurs simultaneously with the /WE low
transitions or after the /WE transition, output remain in a high impedance state.
6. /OE is continuously low (/OE = VIL ).
7. DOUT is the same phase of write data of this write cycle.
8. DOUT is the read data of next address.
9. If /CE1 is low and CE2 is high during this period, DQ pins are in the output state. Then the data
input signals of opposite phase to the outputs must not be applied to them.
10. Transition is measured ±500mV from steady state with CL = 5pF as shown in Figure 1B. The
parameter is guaranteed but not 100% tested.
11. TCW is measured from the later of /CE1 going low or CE2 going high to the end of write.
ORDER INFORMATION
WS6264L
Package:
FP: 28L SOP-330mil
P: 28L PDIP-600mil
Speed:
Temperature:
I: -40~85°C
Blank: 0~70°C
L X
XX
70: 70ns
XX
Package Material:
R: Lead and Halogen Free
-: Normal
Normal-
High Speed Super Low Power SRAM
8K-Word By 8 Bit
WS6264
LL: Low Low power
Russian ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
