AD2S1200YST datasheet(21/25 Pages) AD

21 / 25 page

AD2S1200

Rev. 0 | Page 20 of 24

CLOCK REQUIREMENTS

To achieve the specified dynamic performance, an external

crystal of 8.192 MHz must be used at the CLKIN, XTALOUT

pins. The position and velocity accuracy are guaranteed for

operation with a 8.192 MHz clock. However, the position

accuracy will still be maintained for clock frequencies ±10%

around this value. The velocity outputs are scaled in proportion

to the clock frequency so that if the clock is 10% higher than the

nominal, the full-scale velocity will be 10% higher than

nominal. The maximum tracking rate and the tracking loop

bandwidth also vary with the clock frequency.

CONNECTING TO THE DSP

The AD2S1200 serial port is ideally suited for interfacing to

DSP configured microprocessors. Figure 16 shows the

AD2S1200 interfaced to ADMC401, one of the DSP based

motor controllers.

The on-chip serial port of the ADMC401 is used in the

following configuration:

•

Alternate framing transmit mode with internal framing

(internally inverted)

•

Normal framing receive mode with external framing

(internally inverted)

•

Internal serial clock generation

In this mode, the ADMC401 uses the internal TFS signal as

external RFS to fully control the timing of receiving data and it

uses the same TFS as RD to the AD2S1200. The ADMC401 also

provides an internal continuous serial clock to the AD2S1200.

The SAMPLE signal on the AD2S1200 could be provided either

by using a PIO or by inverting the PWMSYNC signal to

synchronize the position and velocity reading with the PWM

switching frequency. CS and RDVEL may be obtained using two

PIO outputs of the ADMC401. The 12 bits of significant data

plus status bits are available on each consecutive negative edge

of the clock following the low going of the RD signal. Data is

clocked from the AD2S1200 into the data receive register of the

ADMC401. This is internally set to 16 bits (12 bits data, 4 status

bits) because 16 bits are received overall. The serial port

automatically generates an internal processor interrupt. This

allows the ADMC401 to read 16 bits at once and continue

processing.

All ADMC401 products can interface to the AD2S1200 with

similar interface circuitry.

SCLK

TFS

RFS

PWMSYNC

PIO

SCLK

SOE

SAMPLE

RDVEL

ADMC401

AD2S1200

Figure 16. Connecting to the ADMC401

AD2S1200YST датащи(PDF) 21 Page - Analog Devices

AD2S1200YST датащи(HTML) 21 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25

датащи скачать

ссылки URL