PCI7620 datasheet(77/248 Pages) TI

номер детали	PCI7620

подробное описание детали	DUAL SOCKET CARDBUS AND SMART CARD CONTROLLER

PDF	248 Pages

Scroll/Zoom	100%

производитель	TI [Texas Instruments]

домашняя страница	http://www.ti.com

Logo

77 / 248 page

3–32

Therefore, in order to maintain consistent gap-counts throughout the bus, the following rules apply to the use of the

IBR bit, RHB, and Gap_Count in PHY register 1:

•

Following the transmission of a PHY-config packet, a bus reset must be initiated in order to verify that all

nodes have correctly updated their RHBs and Gap_Count values and to ensure that a subsequent new

connection to the bus causes the Gap_Count to be set to 63 on all nodes in the bus. If this bus reset is

initiated by setting the IBR bit to 1, then the RHB and Gap_Count field must also be loaded with the correct

values consistent with the just transmitted PHY-config packet. In the PCI7x20 device, the RHB and

Gap_Count are updated to their correct values upon the transmission of the PHY-config packet, so these

values may first be read from register 1 and then rewritten.

•

Other than to initiate the bus reset, which must follow the transmission of a PHY-config packet, whenever

the IBR bit is set to 1 in order to initiate a bus reset, the Gap_Count value must also be set to 63 so as to

be consistent with other nodes on the bus, and the RHB must be maintained with its current value.

•

The PHY register 1 must not be written to except to set the IBR bit. The RHB and Gap_Count must not be

written without also setting the IBR bit to 1.

PCI7620 датащи(PDF) 77 Page - Texas Instruments