5/6

www.asb.co.kr

September 2017

Low Noise & High OIP3

Medium Power Amplifier Module

1)

The tantal or MLC (Multi Layer Ceramic) capacitor is optional and for bypassing the AC noise introduced

from the DC supply. The capacitance value may be determined by customer’s DC supply status. The ca-

the best electrical performance.

2)

DC blocking capacitors are always necessarily placed at the input and output port for allowing only the

RF signal to pass and blocking the DC component in the signal. The DC blocking capacitors are includ-

ed inside the APM module. Therefore, C1 & C2 capacitors may not be necessary, but can be added just

in case that the customer wants. The value of C1 & C2 is determined by considering the application fre-

quency.

Copyright

2009-2017 ASB Inc. All rights reserved. Datasheet subject to change without notice. ASB assumes no re-

sponsibility for any errors which may appear in this datasheet. No part of the datasheet may be copied or reproduced

in any form or by any means without the prior written consent of ASB.

Application Circuit

Recommended Soldering Reflow Process

20~40 sec

260

C

200

C

150

C

60~180 sec

Ramp-up

(3

C/sec)

Ramp-down

(6

C/sec)

+

-

APM

OUT

IN

C1

C2

Tantal or MLC (Multi Layer Ceramic)

Capacitor

IN

OUT

Vs

Evaluation Board Layout

Size 40x40 mm

(for APM Series – 13x13 mm)