PD035VX1

The information contained herein is the exclusive property of Prime View International Co., Ltd. and shall not be

distributed, reproduced, or disclosed in whole or in part without prior written permission of Prime View International Co.,

Ltd.

Page:6

Note 5-1: Select left or right shift

R/L

DIO1

DIO2

Shift

1

Input

Hi-Z

Left to right

0

Hi-Z

Input

Right to left

Note 5-2: Latch the polarity of outputs and switch the new data to outputs

At the rising edge (LD), latch the “POL” signal to control the polarity of the outputs.

Note 5-3: Control whether the Data R0~G5 are inverted or not. (PVI suggests connecting to GND)

When “REV=1”, these data will be inverted.

EX: “00”→”3F”, “07”→”38”, “15”→”2A”

Note 5-4: Polarity selector for dot-inversion control. Available at the rising edge of LD.

When POL=1: Even outputs range from V1~V7, and Odd outputs range from V8~V14;

When POL=0: Even outputs range from V8~V14, and Odd outputs range from V1~V7.

Note 5-5:

1) Relationship between input data and output voltage

The figure below shows the relationship between the input data and the output voltage with the polarity.

The range of V1~V7 is for positive polarity, and V8~V14 for negative polarity. Please refer to the following

pages to get the related resister values and voltage calculation method.

Positive polarity

Negative polarity

Gamma correction diagram

V1

V2

V3

V4

V5

V6

V7

V8

V9

V10

V11

V12

V13

V14

Vcom

Vss2

00H

08H

10H

18H

20H

28H

30H

38H

3FH

Input Data