CD10.241

CD-Series

DC/DC Converter 24V/24V, 10A, 240W

-25°C to +70°C (-13°F to 158°F)

reduce output power according Fig. 14-1

Storage temperature

-40 to +85°C (-40°F to 185°F)

for storage and transportation

Output de-rating

3.2W/°C

45-60°C (113°F to 140°F)

6W/°C

60-70°C (140°F to 158°F)

5 to 95% r.H.

IEC 60068-2-30

2-17.8Hz: ±1.6mm; 17.8-500Hz: 2g

2 hours / axis

IEC 60068-2-6

30g 6ms, 20g 11ms

3 bumps / direction, 18 bumps in total

IEC 60068-2-27

Altitude

0 to 6000m (0 to 20 000ft)

reduce output power or ambient temperature

above 2000m sea level.

Altitude de-rating

15W/1000m or 5°C/1000m

above 2000m (6500ft), see Fig. 14-2

Over-voltage category

not applicable

The concept of the overvoltage category is

used for equipment energized directly from

the low voltage mains (IEC 60664-1 §4.3.3.2.1).

Degree of pollution

2

IEC 62477-1, not conductive

LABS compatibility

The unit does not release any silicone or other LABS-critical substances and is suitable for

use in paint shops.

Corrosive gases

ISA-71.04-1985, Severity Level G3, IEC 60068-2-60 Test Ke Method 4

Audible noise

Some small audible noise will be emitted from the power supply.

1) Operational temperature is the same as the ambient temperature and is defined as the air temperature 2cm below the unit.

2) Do not energize while condensation is present

3) Tested in combination with DIN-Rails according to EN 60715 with a height of 15mm and a thickness of 1.3mm and standard mounting

orientation. Higher levels allowed when using the wall mounting bracket ZM2.WALL.

Fig. 14-1 Output current vs. ambient temp.

Fig. 14-2 Output current vs. altitude at 24V

0

13/25

-25

0

20

40

70°C

2

4

6

8

10

12A

60

Ambient Temperature

continuous

short

term

Allowable Output

Current at 24V

0

0

2000

4000

6000m

2

4

6

8

10

12A

Altitude

A... Tamb < 60°C

B... Tamb < 50°C

C... Tamb < 40°C

C

B

A

short term

Allowable Output

Current at 24V

Jul. 2017 / Rev. 1.1 DS-CD10.241-EN

All parameters are typical values at 24V, 10A, 24Vdc input voltage, 25°C ambient and

after a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone +49 89 9278 0

Germany