13

TUSB213

www.ti.com

SLLSEX6A – AUGUST 2017 – REVISED AUGUST 2017

Product Folder Links: TUSB213

Submit Documentation Feedback

Copyright © 2017, Texas Instruments Incorporated

8.2.2.1 Test Procedure to Construct USB High Speed Eye Diagram

NOTE

USB-IF certification tests for High Speed eye masks require the mandated use of the

USB-IF developed test fixtures. These test fixtures do not require the use of oscilloscope

probes. Instead they use SMA cables. More information can be found at the USB-IF

Compliance Updates Page. It is located under the ‘Electricals’ section, ID 86 dated March

2013.

The following procedure must be followed before using any oscilloscope compliance software to construct a USB

High Speed Eye Mask:

8.2.2.1.1

For a Host Side Application

1. Configure the TUSB213 to the desired AC and DC Boost settings

2. Power on (or toggle the RSTN pin if already powered on) the TUSB213

3. Using SMA cables, connect the oscilloscope and the USB-IF host-side test fixture to the TUSB213

4. Enable the host to transmit USB TEST_PACKET

5. Execute the oscilloscope USB compliance software.

6. Repeat the above steps in order to re-test TUSB213 with a different settings

8.2.2.1.2

For a Device Side Application

1. Configure the TUSB213 to the desired AC and DC Boost settings

2. Power on (or toggle the RSTN pin if already powered on) the TUSB213

3. Connect a USB host, the USB-IF device-side test fixture, and USB device to the TUSB213. Ensure that the

USB-IF device test fixture is configured to the ‘INIT’ position

4. Allow the host to enumerate the device

5. Enable the device to transmit USB TEST_PACKET

6. Using SMA cables, connect the oscilloscope to the USB-IF device-side test fixture and ensure that the

device-side test fixture is configured to the ‘TEST’ position.

7. Execute the oscilloscope USB compliance software.

8. Repeat the above steps in order to re-test TUSB213 with a different settings