W39V040FAQ datasheet(5/36 Pages) WINBOND

5 / 36 page

W39V040FA

Publication Release Date: December 19, 2002

- 5 -

Revision A2

Hardware Data Protection

The integrity of the data stored in the W39V040FA is also hardware protected in the following ways:

(1) Noise/Glitch Protection: A #WE pulse of less than 15 nS in duration will not initiate a write cycle.

(2) VDD Power Up/Down Detection: The programming and read operation are inhibited when VDD is

less than 1.5V typical.

(3) Write Inhibit Mode: Forcing #OE low or #WE high will inhibit the write operation. This prevents

inadvertent writes during power-up or power-down periods.

(4) VDD power-on delay: When VDD has reached its sense level, the device will automatically time-out

5 mS before any write (erase/program) operation.

Data Polling (DQ7)- Write Status Detection

The W39V040FA includes a data polling feature to indicate the end of a program or erase cycle.

When the W39V040FA is in the internal program or erase cycle, any attempts to read DQ7 of the last

byte loaded will receive the complement of the true data. Once the program or erase cycle is

completed, DQ7 will show the true data. Note that DQ7 will show logical "0" during the erase cycle,

and when erase cycle has been completed it becomes logical "1" or true data.

Toggle Bit (DQ6)- Write Status Detection

In addition to data polling, the W39V040FA provides another method for determining the end of a

program cycle. During the internal program or erase cycle, any consecutive attempts to read DQ6 will

produce alternating 0's and 1's. When the program or erase cycle is completed, this toggling between

0's and 1's will stop. The device is then ready for the next operation.

There are three kinds of registers on this device, the General Purpose Input Registers, the Block Lock

Control Registers and Product Identification Registers. Users can access these registers through

respective address in the 4Gbytes memory map. There are detail descriptions in the sections below.

General Purpose Inputs Register

This register reads the FGPI[4:0] pins on the W39V040FA.This is a pass-through register which can

read via memory address FFBC0100(hex). Since it is pass-through register, there is no default value.

GPI Register Table

BIT

FUNCTION

− 5

Reserved

Read FGPI4 pin status

Read FGPI3 pin status

Read FGPI2 pin status

Read FGPI1 pin status

Read FGPI0 pin status

W39V040FAQ датащи(PDF) 5 Page - Winbond