Page 12/13

LED

LED

Circuit model A

LIGITEK ELECTRONICS CO.,LTD.

Property of Ligitek Only

Circuit model B

Drive Method:

LED is a current operated device, and therefore, requirer some kind of current limiting incorporated into

the driver circuit. This current limiting typically takes the form of a current limiting resistor placed in series

with the LED.

Consider worst case voltage variations than could occur across the current limiting resistor. The forwrd

current should not be allowed to change by more than 40% of its desired value.

(A) Recommended circuit.

(B) The difference of brightness between LED could be found due to the VF-IF characteristics of LED.

ESD(Electrostatic Discharge):

Static Electricity or power surge will damage the LED. Use of a conductive wrist band or anti-electrosatic

glove is recommended when handing these LED. All devices, equipment and machinery must be properly

grounded.

Cleaning:

Use alcohol-based cleaning solvents such as isopropyl alcohol to clean the LED.

PART NO. LRGY9Q53/R2-B01

Precautions For Use:

Storage time:

1. Calculated shelf life before opening is 12 months at < 30°C and < 90% relative humidity (RH)

2. After bag is opened, devices which will be subjected to reflow soldering or other high

temperature processes must be

b) Stored at ambient of 10% RH or less

3. Devices are required baking before assembly if:

a) Humidity Indicator Card reads >10% (for level 2a -5a)

b) 2.a) or 2.b) doesn't meet

4. If baking is required, devices should be baked for >72 hours at 60±5°C / 5% RH.Performing baking

only once, and using the baked devices within 72 hours.