TP3410 datasheet(14/32 Pages) NSC

14 / 32 page

Functional Description (Continued)

82 GCI Frame Structure

Figure 7 shows the frame structure at the GCI interface

One GCI channel supports one TP3410 using a bandwidth

of 256 kbits consisting of the following channels multi-

plexed together in an 8 kHz frame

B1 channel at 8 bits per frame

B2 channel at 8 bits per frame

Monitor (M) channel at 8 bits per frame

Signalling and Control (SC) channel which is structured

as follows

D Channel at 2 bits per frame

CI channel at 4 bits per frame

A bit for acknowledgement of M channel bytes

E bit which indicates byte boundaries when multiple-

byte messages are transferred via the M channel

83 Monitor Channel

The GCI Monitor channel (byte 3) is used to access all the

Command Registers shown in Table II with the exception of

the Activation Control Register and all the Status Registers

shown in Table III with the exception of the Activation Indi-

cation Register Each access to or from one of the listed

registers requires a 2-byte message transfer As shown in

Tables II and III the first byte from the originating device

contains the register address and the second byte is the

data byte Status Registers originate messages in the Moni-

tor channel under control of the Interrupt Stack (in the same

manner as when the TP3410 is used in Microwire Mode) In

addition a protocol is used based on the E and A bits in

byte 4 to provide an acknowledgement of each Monitor

channel byte in either direction see

Figure 8

When no Monitor Channel message is being transferred

the E bit and the A bit in the reverse direction are high-im-

pedance (and pulled high by the external resistor if no other

device is active in that channel) To initiate a transfer a

device must first verify that it has received the A bite1 for at

least 2 consecutive GCI frames from the other device be-

fore starting the transfer It then sends the first byte in the

Monitor channel with the associated E bite0 and repeats

the byte in the next GCI frame Normally the receiving de-

vice will verify receiving the same byte in 2 consecutive

frames and acknowledge this by setting Ae0 for at least 2

frames If not the message is aborted by sending Ae0 for

only 1 frame

On detecting the acknowledgement the sending device

then sends the 2nd of the 2 bytes in 2 consecutive GCI

frames (or until it is acknowledged) with Ee1 to indicate

this is the last byte of the transfer The receiver verifies this

byte is the same for 2 frames and sends an acknowledge-

ment by sending Ae1 in the next frame If an abort is re-

quired the receiver will maintain Ae1 for another frame If a

Monitor channel message originated by the TP3410 is

aborted it will repeat the complete message until it is suc-

cessfully acknowledged

84 CI Channel

The CI (CommandIndicate) channel in GCI byte 4 is used

solely to access the Activation Control Register and the Ac-

tivation Indication Register in the TP3410 A complete de-

scription of these registers is found in Section 11 including

the coding of the 4-bit messages Unlike the Microwire

Mode of the device however the contents of these 2 regis-

ters are transferred repeatedly in the CI channel once per

GCI frame A change in transmit message is originated by a

change in the Activation Indication Register while a change

in received message is verified in 2 consecutive GCI frames

before updating the Activation Control Register and taking

the appropriate action

TLH9151 – 16

Note 1

As an output (GCI Master) FSa is high for 8-bit intervals (16 BCLK cycles) As an input (GCI Slave) FSa must be high for t 1 BCLK cycle

Note 2

The FSb output is provided only in GCI Master Mode

FIGURE 7 GCI Frame Structure is an Example of Multiplex Mode with BCLK e 4096 MHz

TLH9151 – 27

FIGURE 8 GCI Monitor Channel and E and A Bit Protocol

TP3410 датащи(PDF) 14 Page - National Semiconductor (TI)

TP3410 датащи(HTML) 14 Page - National Semiconductor (TI)

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32

датащи скачать

ссылки URL