STM32F410CB datasheet(21/142 Pages) STMICROELECTRONICS

21 / 142 page

DocID028094 Rev 5

21/142

STM32F410x8/B

Functional overview

3.15

Power supply supervisor

3.15.1

Internal reset ON

This feature is available for VDD operating voltage range 1.8 V to 3.6 V.

The internal power supply supervisor is enabled by holding PDR_ON high.

The device has an integrated power-on reset (POR) / power-down reset (PDR) circuitry

coupled with a Brownout reset (BOR) circuitry. At power-on, POR is always active, and

ensures proper operation starting from 1.8 V. After the 1.8 V POR threshold level is

reached, the option byte loading process starts, either to confirm or modify default

thresholds, or to disable BOR permanently. Three BOR thresholds are available through

option bytes.

The device remains in reset mode when VDD is below a specified threshold, VPOR/PDR or

VBOR, without the need for an external reset circuit.

The device also features an embedded programmable voltage detector (PVD) that monitors

the VDD/VDDA power supply and compares it to the VPVD threshold. An interrupt can be

generated when VDD/VDDA drops below the VPVD threshold and/or when VDD/VDDA is

higher than the VPVD threshold. The interrupt service routine can then generate a warning

message and/or put the MCU into a safe state. The PVD is enabled by software.

3.15.2

Internal reset OFF

This feature is available on WLCSP36 package only. The internal power-on reset (POR) /

power-down reset (PDR) circuitry is disabled by setting the PDR_ON pin to low.

An external power supply supervisor should monitor VDD and should set the device in reset

mode when VDD is below 1.7 V. NRST should be connected to this external power supply

supervisor. Refer to Figure 4: Power supply supervisor interconnection with internal reset

OFF.

Figure 4. Power supply supervisor interconnection with internal reset OFF(1)

1. The PRD_ON pin is available on WLCSP36 package only.

STM32F410CB датащи(PDF) 21 Page - STMicroelectronics