| поискавой системы для электроныых деталей |
|
ST10F296 датащи(PDF) 155 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
ST10F296 датащи(HTML) 155 Page - STMicroelectronics |
|
155 / 346 page ![]() Obsolete Product(s) - Obsolete Product(s) ST10F296E Parallel ports 155/346 Figure 49. Port 6 I/O and alternate functions The chip select lines of Port 6 have an internal weak pull-up device. This device is switched on under the following conditions: ● During reset ● If Port 6 line is used as a chip select output, the ST10F296E is in hold mode, and the respective pin driver is in push-pull mode (ODP6.x = 0). The pull-up device is implemented to drive the chip select lines high during reset to avoid multiple chip selection and to allow another master to access the external memory via the same chip select lines (AND-wired) while the ST10F296E is in hold mode. When ODP6.x = 1 (open-drain output selected), the internal pull-up device is active during hold mode and external pull-up devices must be used in this case. When entering hold mode the CS lines are actively driven high for one clock phase, at which point the output level is controlled by the pull-up devices (if activated). After reset the CS function must be used. In this case, the port latches cannot be programmed and the alternate function (CS) is selected automatically. Table 92. Port 6 alternate functions Port 6 pin Alternate function CSSEL = 10 Alternate function CSSEL = 01 Alternate function CSSEL = 00 Alternate function CSSEL = 11 P6.0 General purpose I/O Chip select CS0 Chip select CS0 Chip select CS0 P6.1 General purpose I/O Chip select CS1 Chip select CS1 Chip select CS1 P6.2 General purpose I/O SCLK1 General purpose I/O SCLK1 Chip select CS2 SCLK1 Chip select CS2 SCLK1 P6.3 General purpose I/O MTSR1 General purpose I/O MTSR1 General purpose I/O MTSR1 Chip select CS3 MTSR1 P6.4 General purpose I/O MRST1 General purpose I/O MRST1 General purpose I/O MRST1 Chip select CS4 MRST1 P6.5 HOLD external hold request input P6.6 HLDA hold acknowledge output P6.7 BREQ bus request output Port 6 Alternate function (a) General purpose input/output (b) XSSC input/output Bus arbitration P6.7 P6.6 P6.5 P6.4 P6.3 P6.2 P6.1 P6.0 - - - - - - - - BREQ HLDA HOLD CS4 CS3 CS2 CS1 CS0 - - - - - - - - BREQ HLDA HOLD MRST1 MTSR1 SCLK1 CS1 CS0 - - - - - - - - Obsolete Product(s) - Obsolete Product(s) |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |