GAMEWELL-FCI

12 Clintonville Road, Northford, CT 06472-1610 USA • Tel: (203) 484-7161 • Fax: (203) 484-7118

Specifications are for information only, are not intended for installation purposes, and are subject to change without notice. No responsibility is assumed by Gamewell-FCI for their use.

©2013 Honeywell International Inc. All rights reserved.

www.gamewell-fci.com

9020-0626 Rev. E page 1 of 1

AMM-2F

Addressable Monitor Module

Description

monitor module AMM-2F is a single Style B, Class B

initiating device circuit (IDC) with a 47KW end-of-line

resistor. This module provides an address for any

device or group of devices connected to this circuit

on the signaling line circuit (SLC) of the Gamewell-

FCI addressable series fire alarm control panel. Any

initiating device with normally open (N.O.) dry con-

tacts may be made addressable when connected to

the AMM-2F module.

that substantially increases the speed of communi-

cation between the sensors and certain Gamewell-

FCI analog addressable fire alarm controls. These

devices operate in a grouped fashion. If one of the

devices in the group has a status change, the

panel’s microprocessor stops the group poll and

concentrates on the single device. The net effect is

response speed up to five times greater than earlier

designs.

The AMM-2F module can be programmed to provide

a wide variety of input functions to the Gamewell-FCI

addressable series fire alarm control panels. It can

be identified as a manual station, heat detector, ple-

num detector, waterflow switch, tamper switch, N.O.

contact, smoke detector, projected beam smoke

detector, sub loop, remote zone, etc. It can also

serve as a remote system silence, system reset,

system acknowledge or drill switch. It is even possi-

ble to customize its device type to meet specific job

requirements.

The initiating device circuit of the AMM-2F can sup-

port a maximum line resistance of up to 40 ohms

allowing the use of linear heat detection devices. The

compact size facilitates the installation of the module

inside manual stations, or mounting boxes of various

types of alarm initiating devices.

Features

•

Compact size allows easy installation

•

Class B, Style B, initiating circuit

•

40 Ohm line resistance for each initiating device circuit

•

Connects to any normally open dry contact device

Specifications

Supervisory Current:

.000375 amps

Alarm Current:

.00060 amps

Operating Temperature: 32° to 120° F (0° to 49° C)

Relative Humidity:

10 to 93%

(non-condensing)

End-of-Line Resistance: 47K ohms

Dimensions:

1.3” L x 2.5” W x 0.5” D

(3.3 x 6.4 x 1.3 cm)

Ordering Information

Part Number

Description

AMM-2F

Addressable monitor module, single

circuit, Style B, Class B

AMM-2F

7300-1703:0102

3023594

227-03-E VOL IV

MEA

Approved

S1949

SIGNALING

APPROVED

FM