PISA11

PISA11-Series

This device is designed for installation in an enclosure and is intended for the general use such as in industrial control,

office, communication, and instrumentation equipment.

Do not use this protection module in equipment, where malfunction may cause severe personal injury or threaten

human life.

This device is designed for use in hazardous, non-hazardous, ordinary or unclassified locations.

This protection module fulfills two basic functions. First it distributes the current of a large power source to four lower

current output channels and therefore allows for smaller wires to be used. The second function is to permit only so

much current on the outputs that the input voltage of this unit (which corresponds to the output voltage of the power

supply) does not fall below 21V. This ensures a reliable supply voltage for sensitive equipments, such as PLCs, controls

or sensors, when they are connected directly to the same power supply as the PISA protection module.

The protection module has one 24V input and four output channels to which the current is distributed. Each output

channel is equipped with a redundant over-current protection, which avoids that wires will be overloaded. All four

output channels will shutdown simultaneously, if the current of one individual channel or the maximum allowed

current for the protection module is exceeded.

A safeguard circuit in the input stage of the PISA module works like a valve. It permits only so much current that the

input voltage does not drop below 21V. In case the input voltage would fall below this value (e.g. due to overloads,

too small of a power supply or high inrush currents such as from starting a motor), all four output channels will be

actively current limited and will shutdown after a certain period of time.

A typical wiring configuration is shown below. All sensitive loads are connected directly to the power supply. If

needed, these load circuits can be protected with standard circuit breakers or fuses. Loads which are less sensitive to

voltage dips or interruptions or which are the source

of the voltage drop themselves are connected to th

output of the PISA protection module.

DC 24V

Power

Supply

Relays, Solenoids

Displays

Motor 2

Motor 1

A1

A2

A4

A3

PLC, controls

(sensitive loads)

PISA Protection Module

Safeguard

e

This protection module is suitable for DIN-rail mounting. Use DIN-Rails according to EN 60715 or EN 50022 with a

height of 7.5 or 15mm.

The protection module can be used with any regulated 24Vdc power supply. If the power source can deliver more than

40A continuous, the PISA module shall be equipped with an external input fuse (e.g. 30/32A). The power capability

and performance of the power supply can limit the output characteristics of the PISA module.

Make sure that the input voltage polarity is correct before applying the input voltage.

Do not connect batteries to the outputs of the PISA11 module.

This device may only be installed and put into operation by qualified personnel.

The unit does not contain serviceable parts.

If damage or malfunction should occur during operation, immediately turn power off and send unit to the factory for

inspection.

May 2014 / Rev. 1.7 DS-PISA11 - data sheet -

All parameters are specified at 24Vdc input, 25°C ambient temperature and a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone +49 89 9278-0

Germany

3/23