P1602 Specifications

Parameter

Value

Units

Notes

Electrical @ 71.6°F (22°C) unless noted

Excitation

1.00

mA

10 VDC maximum

Input Impedance

5000 ±20%

Ω

Output Impedance

5000 ±20%

Ω

Environmental

Operating Temperature

-40 to 257

°F

(-40°C to 125°C)

Storage Temperature

-67 to 302

°F

(-55°C to 150°C)

(undiced)

Maximum Overpressure

6X

Rated pressure

2X

3

Mechanical

Weight

0.02

Grams

xx lb

Media Compatibility

Clean dry

air, non-

corrosive

gases

Performance

Parameters (1)

Value (6)

Units

Notes

Zero Offset

±8

mV/V

±10

mV/V

2

Full-scale (FS) Output

65 to 115

mV

2

75 to 125

mV

170 to 280

mV

3

Linearity

±0.2

%FSO

4

±0.25

%FSO

3, 4

Pressure Hysteresis

±0.1

%FSO

Temperature

Coefficient of Zero

±30

µV/V/°C

5

Temperature

Coefficient of Resistance

0.3

% /°C

5

Temperature Coefficient

of Sensitivity

-0.2

%/°C

5

Thermal Hysteresis of Zero

±0.1

%FSO

6

Long Term Stability of FSO

0.2

%FSO

7

1. Values measured at 1.0 mA and 71.6°F (22°C) unless noted.

2. 100 Kpa pressure range.

3. 4295 psia (296.12 bar) pressure range.

4. Best fit straight line.

5. Between 32°F and 158°F (0°C and 70°C). Temperature coefficients are typical values.

6. Between 32°F and 158°F (0°C and 70°C).

7. Typical over one year.

Shipping and Handling

Wafers are shipped in protective plastic containers. The wafers are

sawn on sticky tape with rings. All sensor wafers are electrically

probed, visually inspected. All rejects are marked by an ink dot. Each

wafer will be labeled with the lot number, wafer number, device num-

ber, and the number of available sensor die.

Warranty

NovaSensor warrants its products against defects in material and

workmanship for 12 months from the date of shipment. Products

not subjected to misuse will be repaired or replaced. NovaSensor

reserves the right to make changes without further notice to any

products herein. NovaSensor makes no warranty, representation or

guarantee regarding the suitability of its products for any particular

application. NovaSensor does not assume any liability arising out of

the application or use of any product or circuit and specifically dis-

claims, and all liability, without limitation consequential or incidental

damages. The foregoing warranties are exclusive and in lieu of all

other warranties, whether written, oral, implied or statutory. No im-

plied statutory warranty of merchantabilility or fitness for particular

purpose shall apply.

AAS-920-265B-08/2014

www.amphenol-sensors.com

© 2014 Amphenol Corporation. All Rights Reserved. Specifications are subject to change without notice.

Other company names and product names used in this document are the registered trademarks or

trademarks of their respective owners.

Amphenol

Advanced Sensors

Die dimensions (w x h x d):

0.04 in x 0.04 in x 0.02 in

(1 mm x 1 mm x 0.6 mm)

P1602 schematic and dimensions

Ordering Information

Minimum Release Quantity:

2 wafers per pressure range or approximately 10,000 sensor die.

Part Number

Description

51393

15 psia (1 bar); ≈100 kPaA

51394

30 psia (2.06 bar); ≈200 kPaA

51395

50 psia (3.44 bar); ≈350 kPaA

51397

100 psia (6.89 bar); ≈700 kPaA

51399

150 psia (10.34 bar); ≈1035 kPaA

51406

300 psia (20.68 bar); ≈2070 kPaA

51407

500 psia (34.47 bar); ≈3450 kPaA

51408

1000 psia (68.94 bar); ≈6895 kPaA

51421

2500 psia (172.36 bar); ≈17,240 kPaA

51409

4295 psia (296.12 bar); ≈30,000 kPaA

Pad dimensions (w x h):

0.005 in x 0.005 in

(0.13 mm x 0.13 mm)