UG-277 datasheet(4/24 Pages) AD

4 / 24 page

UG-277

SDP User Guide

Rev. B | Page 4 of 24

GETTING STARTED

This section provides specific information to assist you with

using the SDP-B board as part of your evaluation system.

The following topics are covered:

•

Package contents

•

PC configuration

•

USB installation

•

Powering up/powering down the SDP

PACKAGE CONTENTS

Your EVAL-SDP-CB1Z board package contains the following:

•

EVAL-SDP-CB1Z board

•

1 m USB Standard-A to Mini-B cable

Contact the vendor where you purchased your SDP-B board or

contact Analog Devices if anything is missing.

PC CONFIGURATION

For correct operation of the SDP board, your computer must

have the following minimum configuration:

•

Windows XP Service Pack 2 or Windows Vista®

•

USB 2.0 port

When removing the SDP-B board from the package, handle the

board carefully to avoid the discharge of static electricity, which

can damage some components.

USB INSTALLATION

Perform the following tasks to safely install the SDP-B board

onto the computer. There are two stages in the software

application installation procedure. The first stage installs the

application software. The second stage installs the .NET

Framework 3.5 and the necessary drivers.

Installing the Software

1. Run the application install provided. The first stage installs

the applications GUI and the necessary support files onto

the computer

2. Immediately following the application install, the .NET

Framework 3.5 and the driver package for the SDP board is

installed. If the .NET Framework 3.5 is already preinstalled

on the computer in question, this stage is skipped and Step

2 will consist of a driver package installation only

Connecting the SDP-B Board to the PC

Attach the SDP-B board to a USB 2.0 port on the computer via

the Standard-A to Mini-B cable provided.

Verifying Driver Installation

Before using the SDP-B board, verify the driver software has

installed properly.

Open the Windows Device Manager and verify the SDP board

appears under ADI Development Tools as shown in Figure 1.

Figure 1. Device Manager

POWERING UP/POWERING DOWN THE SDP

The following sections describe how to safely power up and

power down the SDP-B.

Powering Up the SDP-B Board

1. Connect the SDP-B board to the daughter evaluation board

through the 120-pin mating connectors.

2. Power the daughter board.

3. Connect the USB port on the computer to the SDP-B

board.

Powering Down the SDP-B Board

1. Power down the daughter evaluation board.

2. Disconnect the USB port on the computer from the SDP-B

board.

3. Disconnect the SDP-B board from the daughter evaluation

board.

UG-277 датащи(PDF) 4 Page - Analog Devices

UG-277 датащи(HTML) 4 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24

датащи скачать

ссылки URL