ZLED7010 datasheet(10/22 Pages) IDT

10 / 22 page

ZLED7010 Datasheet

April 20, 2016

ADJ

OUT

079

∗

2.3.2.

PWM Control

The output current on LX can be set to a value below the nominal average value determined by resistor RS by

using an external PWM signal as the control signal applied to the ADJI pin. This control signal must be capable of

driving the ZLED7010

’s internal 500kΩ pull-up resistor. See Figure 2.1 for an illustration. The minimum signal

voltage range is 0V to 1.8V; the maximum voltage range is 0V to 5V. See section 1.3 for the specifications for the

signal’s duty cycle DPWM. Any negative spikes on the control signal could interfere with current control or proper

operation of the ZLED7010.

Figure 2.1

Directly Driving ADJI Input with a PWM Control Signal

2.3.3.

External DC Voltage Control of Output Current

The output current on LX can be set to a value below the nominal average value determined by resistor RS by

using an external DC voltage VADJ (0.3 V

≤ V

ADJ

≤ 1.2V) to drive the voltage at the ADJ

I pin. This allows adjusting

the output current from 25% to 100% of IOUTnom. See Figure 2.2 for an illustration. The output current can be

calculated using equation (2). If VADJ matches or exceeds VREF (1.2V), the brightness setting is clamped at its

maximum (100%).

Figure 2.2

External DC Control Voltage at ADJI Pin

ADJI

ADJO

GND

ZLED7010

(2)

Where

IOUT_DC = Nominal average output current through the LED(s) with a DC control voltage

VADJ = External DC control voltage: 0.3V

≤ V

ADJ

≤ 1.2V

≥0.13Ω

PWM

1.8V to 5V

ADJI

ADJO

GND

ZLED7010

ZLED7010 датащи(PDF) 10 Page - Integrated Device Technology

ZLED7010 датащи(HTML) 10 Page - Integrated Device Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22

датащи скачать

ссылки URL