© KEMET Electronics Corporation • P.O. Box 5928 • Greenville, SC 29606 (864) 963-6300 • www.kemet.com

C1003_C0G • 4/30/2014

3

Surface Mount Multilayer Ceramic Chip Capacitors (SMD MLCCs) – C0G Dielectric, 10 – 200 VDC (Commercial Grade)

Qualification/Certification

CommercialGradeproductsaresubjecttointernalqualification.Detailsregardingtestmethodsandconditionsarereferencedin

Table 4, Performance and Reliability.

Environmental Compliance

Lead (Pb)-Free, RoHS, and REACH compliant without exemptions.

Electrical Parameters/Characteristics

Item

Parameters/Characteristics

Operating Temperature Range

-55°C to +125°C

Capacitance Change with Reference to +25°C and 0 VDC Applied (TCC)

±30 ppm/ºC

Aging Rate (Maximum % Capacitance Loss/Decade Hour)

0%

Dielectric Withstanding Voltage (DWV)

250% of rated voltage

(5 ±1 seconds and charge/discharge not exceeding 50 mA)

Dissipation Factor (DF) Maximum Limit @ 25ºC

0.1%

Insulation Resistance (IR) Limit @ 25°C

1,000megohmmicrofaradsor100GΩ

(Rated voltage applied for 120 ±5 seconds @ 25°C)

To obtain IR limit, divide MΩ-µF value by the capacitance and compare to GΩ limit. Select the lower of the two limits.

Capacitance and Dissipation Factor (DF) measured under the following conditions:

1 MHz ±100 kHz and 1.0 Vrms ±0.2 V if capacitance ≤ 1,000 pF

1 kHz ±50 Hz and 1.0 Vrms ±0.2 V if capacitance > 1,000 pF

Note: When measuring capacitance it is important to ensure the set voltage level is held constant. The HP4284 and Agilent E4980 have a feature known as

Automatic Level Control (ALC). The ALC feature should be switched to "ON."

Post Environmental Limits

High Temperature Life, Biased Humidity, Moisture Resistance

Dielectric

Rated DC

Voltage

Capacitance

Value

Dissipation Factor

(Maximum %)

Capacitance

Shift

Insulation

Resistance

C0G

All

All

0.5

0.3% or ±0.25 pF 10% of Initial Limit