LOC B

Figure 9

2. Insert ground wire into ferrule. See Figure 10.

On six smaller ferrules (Part No. 327192 and

323930 through 323934) slide the ground wire

insulation under ferrule skirt approximately /16

inch. On five larger ferrules (Part No. 327137

through 327141. DO NOT slide the ground wire

insulation under ferrule skirt.

Figure 10

Hand Tool

a.Open tool handles all the way.

b.Place ferrule with shielded wire and ground

ferrule all the way into tool. See Figure 11.

c.Hold ground wire and shielded wire in

position and close handles until CERTI-CRIMP

tool ratchet releases. Open handles and

remove crimped ferrule.Pneumatic Tool

Pneumatic Tool

a.Place ferrule, with shielded wire and ground

wire attached, in lower crimp area of dies.

Push ferrule all the way into tool. See Figure 1

b.Hold ground wire and shielded wire in

position and depress take-up lever to hold

ferrule in place.

c.Simultaneously release take-up lever and

depress trigger to complete crimp. Release

trigger and remove crimped ferrule.

Figure 11

C. Ferrule Insulating Caps

1. Place insulating cap on ferrule as shown in

Figure 12.

2. Insulating caps are color coded for easy

matching with ferrule. To select correct insulating

cap, refer to Figure 1.

Figure 12

NOTE

i

5 of 8

408-1662

Rev A