KMA36R PERIPHERAL MODULE

Digital Magnetic Encoder Sensor

Page 4

Detailed Description

I

The peripheral module can interface to the host in one of two ways. It can plug directly into a Pmod-compatible port (configured for I

through connector J1, or in this case, other I

I

Alternatively, the peripheral module can connect to other I

2

C-based Pmod modules through the expansion J2 connector. Connector J1

provides connection of the module to the Pmod host. The pin assignments and functions adhere to the Pmod standard as shown in Table 1.

The J2 connector allows the module to be connected through a daisy-chain from another I

2

C module and/or provide I

2

C and power

connections to other I

2

C modules on the same bus. See Table 2.

External Control Signals

The IC operates as an I

connector). In cases where one or more of the SCL and SDA signals are driven from an external source, resistors R1, R2 provide pull-up.

However, this also increases the apparent load to the external driving source. If the external source is incapable of driving these loads, they

should be removed.

Reference Material

•

Refer to the

spec.com/downloads/xxxxxxxxx.pdf

•

ZedBoard Driver)

•

(KMA36R MicroZed Board Driver)

•

(MicroZed Touch Screen Demo)

Ordering Information

Description

Part Number

KMA36R PERIPHERAL MODULE

DPP401Z000

te.com/en/products/sensors.html

TE Connectivity, TE Connectivity (logo) and Every Connection Counts are trademarks. All other logos, products and/or

company names referred to herein might be trademarks of their respective owners.

The information given herein, including drawings, illustrations and schematics which are intended for illustration purposes

only, is believed to be reliable. However, TE Connectivity makes no warranties as to its accuracy or completeness and

disclaims any liability in connection with its use. TE Connectivity‘s obligations shall only be as set forth in TE

Connectivity‘s Standard Terms and Conditions of Sale for this product and in no case will TE Connectivity be liable for any

incidental, indirect or consequential damages arising out of the sale, resale, use or misuse of the product. Users of TE

Connectivity products should make their own evaluation to determine the suitability of each such product for the specific

application.

© 2015

TE Connectivity Ltd. family of companies

All Rights Reserved.

000000XX

03/15

Original

PRODUCT SHEET

Contact us:

Measurement Specialties Inc – MEAS France

31027 Toulouse Cedex 3, FRANCE

Tel:+33 (0)5 820.822.02 Fax:+33 (0)5.820.821.51