PCA9504A datasheet(21/29 Pages) PHILIPS

21 / 29 page

Philips Semiconductors

Product data

PCA9504A

Glue chip 4

2004 May 11

SW00591

A20M*

GPO_FLUSH_CACHE*

INIT*

FLUSH_OUT_CPU*

FLUSH_OUT_FWH*

INIT_OUT*

Figure 12. Waveforms for Case 7

SW00592

A20M*

GPO_FLUSH_CACHE*

INIT*

FLUSH_OUT_CPU*

FLUSH_OUT_FWH*

INIT_OUT*

Figure 13. Waveforms for boundary GPO_FLUSH_CACHE* Case

• Timings should remain the same for both a 66 MHz or 33 MHz

CLK_IN input.

• The boundary condition for INIT listed above, is a special case

where immediately following the FLUSH_OUT*, INIT_OUT* cycle,

the ICH2 asserts INIT* into the Glue Chip.

• The boundary condition for GPO_FLUSH_CACHE* listed above,

is a special case where immediately following the first assertion of

GPO_FLUSH_CACHE*, the GPO is de-asserted, then re-asserted

again before the timings have had a chance to complete.

NOTE:

1. Nominal timing values with tolerances are listed in the DC

Characteristics table.

GPO_FLUSH_CACHE* – input to logic, GPO from the ICH2,

programmed active LOW.

INIT* – input to logic, INIT* signal from the ICH2.

A20M* – input to logic, A20M* signal from the ICH2.

FLUSH_OUT_CPU* – output of logic, route to CPU FLUSH* pin.

FLUSH_OUT_CPU* – output of logic, routed to FWH INIT* pin.

INIT_OUT* – output of logic, routed to CPU INIT* pin.

PCA9504A датащи(PDF) 21 Page - NXP Semiconductors