SAW FILTER

HDF374E

S4

www.shoulder.cn

Tel:0755-82916880

Fax:0755-82916881

E-mail:info@shoulder.cn

Page 6 of 9

6.Reliability

6.1 Mechanical Shock: The components shall remain within the electrical specifications after 1000 shocks,

acceleration 392m/s

6.2 Vibration Fatigue: The components shall remain within the electrical

specifications after loaded vibration at 20 Hz , amplitude 1.5mm , for 2 hours.

6.3 High Temperature Storage: The components shall remain within the electrical specifications after being kept at

the 85℃±2℃for 48 hours, then kept at room temperature for 2 hours.

6.4 Low Temperature Storage: The components shall remain within the electrical specifications after being kept at

the -25℃±2℃for 48 hours ,then kept room temperature for 2 hours.

6.5 Temperature Cycle: The components shall remain within the electrical specifications after 5 cycles of high

and low temperature testing(one cycle: 80℃for 30 minutes

®25℃for 5 minutes ® -25℃for 30 minutes ) than

kept at room temperature for 2 hours.

6.6 Solder-heat Resistance : The components shall remain within the electrical

specifications after dipped in the solder at 260℃for 10±1seconds,then kept at room

temperature for 2

hours .(Terminal must be dipped leaving 1.5 mm from the case).

6.7 Solder ability: Solder ability of terminal shall be kept at more than 80% after dipped in the solder flux at 230℃

± 5℃for 5±1 seconds.

7.Remarks

7.1 Static voltage

Static voltage between signal load & ground may cause deterioration & destruction of the component.

Please avoid static voltage .

7.2 Ultrasonic cleaning

Ultrasonic vibration may cause deterioration & destruction of the component. Please avoid ultrasonic

cleaning.

7.3 Soldering

Only leads of component may be soldered. Please avoid soldering another part of component.

Performance of

SAWTEK855898