LT1030C

QUADRUPLE LOW-POWER LINE DRIVER

SLLS048F – APRIL 1989 – REVISED APRIL 1998

3

POST OFFICE BOX 655303

0 V to 15 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

0 V to –15 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

0 V to 12 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Duration of output short circuit to

±30 V at (or below) 25°C (see Note 2)

Unlimited

. . . . . . . . . . . . . . . . . . . . . . .

Package thermal impedance,

127

°C/W

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

N package

78

°C/W

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

–65

°C to 150°C

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Lead temperature 1,6 mm (1/16 inch) from case for 10 seconds

260

°C

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

† Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and

functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not

implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.

NOTES:

1. All voltage values, except differential voltages, are with respect to GND.

2. The output may be shorted to either supply. Temperature and/or supply voltages must be limited to ensure that the maximum

dissipation rating is not exceeded.

3. The package thermal impedance is calculated in accordance with JESD 51, except for through-hole packages, which use a trace

length of zero.

recommended operating conditions

MIN

MAX

UNIT

Supply voltage, VCC+

5

15

V

Supply voltage, VCC–

–5

–15

V

High-level input voltage, VIH (see Note 4)

2

15

V

Low-level input voltage, VIL (see Note 4)

0.8

V

Operating free-air temperature, TA

0

70

°C

NOTE 4: These VIH and VIL specifications apply only for inputs IN1–IN4. For operating levels for ON/OFF, see Figure 2.

otherwise noted)

PARAMETER

TEST CONDITIONS

MIN

TYP‡

MAX

UNIT

VOM+

Maximum positive peak output voltage swing

IO = –2 mA,

TA = 25°C

VCC+–0.3

VCC+–0.1

V

VOM–

Maximum negative peak output voltage swing

IO = 2 mA,

TA = 25°C

VCC–+0.9

VCC–+1.4

V

IIH

High-level input current

VI ≥ 2 V,

TA = 25°C

2

20

µA

IIL

Low-level input current

VI ≤ 0.8 V,

TA = 25°C

–10

–20

µA

II

Input current ON/OFF

VI = 0

–0.1

–10

µA

II

Input current, ON/OFF

VI = 5 V

30

65

µA

IO

Output current

TA = 25°C

5

12

mA

IOZ

Off-state output current

VO = ±15 V, TA = 25°C,

ON/OFF at 0.4 V

±2

±100

µA

ICC

Supply current (all outputs low)

VI ≥ at 2.4 V, IO = 0

500

1000

µA

ICC( ff)

Off state supply current

ON/OFF at 0.4 V

10

µA

ICC(off)

Off-state supply current

ON/OFF at 0.1 V

10

150

µA

‡ All typical values are at VCC± = ±12 V, TA = 25°C.