93C46B datasheet(9/38 Pages) MICROCHIP

9 / 38 page

 2002-2013 Microchip Technology Inc.

DS20001749K-page 9

93AA46A/B/C, 93LC46A/B/C, 93C46A/B/C

2.6

Erase/Write Disable and Enable

(EWDS/EWEN)

The 93XX46A/B/C powers up in the Erase/Write Disable

(EWDS) state. All programming modes must be preceded

by an Erase/Write Enable (EWEN) instruction. Once the

EWEN instruction is executed, programming remains

enabled until an EWDS instruction is executed or Vcc is

removed from the device.

To protect against accidental data disturbance, the EWDS

instruction can be used to disable all erase/write functions

and should follow all programming operations. Execution

of a READ instruction is independent of both the EWEN

and EWDS instructions.

FIGURE 2-5:

EWDS TIMING

FIGURE 2-6:

EWEN TIMING

2.7

Read

The READ instruction outputs the serial data of the

addressed memory location on the DO pin. A dummy

zero bit precedes the 8-bit (if ORG pin is low or A-version

devices) or 16-bit (if ORG pin is high or B-version

devices) output string.

The output data bits will toggle on the rising edge of the

CLK and are stable after the specified time delay (TPD).

Sequential read is possible when CS is held high. The

memory data will automatically cycle to the next register

and output sequentially.

FIGURE 2-7:

READ TIMING

CLK

•••

TCSL

CLK

TCSL

•••

CLK

•••

High-Z

•••

93C46B датащи(PDF) 9 Page - Microchip Technology

93C46B датащи(HTML) 9 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38

датащи скачать

ссылки URL