 |
поискавой системы для электроныых деталей |
|
|
поискавой системы для электроныых деталей |
|
WM8962B датащи(PDF) 1 Page - Wolfson Microelectronics plc |
|
|
|||||||||||||||||||||||||||||
WM8962B датащи(HTML) 1 Page - Wolfson Microelectronics plc |
|
|
1 / 295 page  Ultra-Low Power Stereo CODEC with Audio Enhancement DSP, 1W Stereo Class D Speaker Drivers and Ground Referenced Headphone Drivers http://www.cirrus.com Copyright Cirrus Logic, Inc., 2009–2015 (All Rights Reserved) Rev 4.3 JUN ‘15 WM8962 DESCRIPTION The WM8962 is a low power, high performance stereo CODEC designed for portable digital audio applications. An integrated charge pump provides a ground referenced output which removes the need for DC-blocking capacitors on the headphone outputs, and uses the Wolfson ‘Class-W’ amplifier techniques - incorporating an innovative dual-mode charge pump architecture - to optimise efficiency and power consumption during playback. A DC Servo is used to reduce DC ground offsets. This improves power consumption and minimises pops and clicks. Stereo class D speaker drivers provide 1W per channel into 8 loads, or 2W mono into a 4 load, with a 5V supply. Low leakage, excellent PSRR and pop/click suppression mechanisms also allow direct battery connection to the speaker supply. Flexible speaker boost settings allow speaker output power to be maximised while minimising other analogue supply currents. Control sequences for audio path setup can be pre-loaded and executed by an integrated sequencer to reduce software driver development and eliminate pops and clicks via SilentSwitch™ technology. Flexible input configuration: four stereo inputs or eight mono inputs on Left or Right ADC, with a complete analogue (four single-ended stereo inputs) and digital microphone interface. External component requirements are drastically reduced as no separate microphone, speaker or headphone amplifiers are required. Advanced on-chip digital signal processing performs automatic level control for the microphone or line input. Stereo 24-bit sigma-delta ADCs and DACs are used with low power over-sampling digital interpolation and decimation filters and a flexible digital audio interface. A programmable audio enhancement DSP is included with multiple preset algorithms. Virtual Surround Sound widens the stereo speaker audio image, HD Bass enhances low frequencies, and ReTuneTM flattens the frequency response of the speaker or microphone path. A configurable DSP includes additional functions such as 3D widening for recording, a 5-band parametric EQ and Dynamic Range Controller. Two high performance PLLs and one Frequency Locked Loop (FLL) are integrated to enable the user to clock a full audio system. The WM8962 operates at analogue supply voltages down to 1.7V, although the digital supplies can operate at voltages down to 1.62V to save power. The speaker supply can operate at up to 5.5V. Unused functions can be disabled using software control to save power. The WM8962 is supplied in a very small W-CSP package, ideal for use in hand-held and portable systems. FEATURES DAC SNR 98dB (‘A’ weighted), THD -84dB at 48kHz, 1.8V ADC SNR 94dB (‘A’ weighted), THD -85dB at 48kHz, 1.8V Stereo Class D Speaker Driver - 1W per channel into 8 BTL speakers - 2W mono into 4 BTL speakers - Flexible internal switching clock Wolfson ‘Class-W’ ultra-low power headphone driver - Up to 31mW per channel output power at 1% THD+N into 16 at 1.8V - Ground Referenced - Low offset (+/- 1.2mV) - Pop and click suppression - Control sequencer for pop-minimised power-up/down - Single register write for default start-up sequence Microphone Interface - Single ended four stereo analogue input - Integrated low noise MICBIAS - Digital microphone interface - Programmable ALC / Limiter and Noise Gate Programmable Audio Enhancement DSP with Presets - Virtual Surround Sound - HD Bass - ReTuneTM Fixed Audio Processing DSP - 3D stereo widening - 5-band Parametric EQ - Dynamic range controller - Beep generator Two integrated PLLs enable clocking of full audio system Low Power Consumption - 7.7mW headphone playback - 8.3mW analogue record mode Low Supply Voltages - Analogue 1.7V to 2.0V (Speaker supply up to 5.5V) - Charge pump 1.7V to 2.0V - MIC bias amp supply 1.7V to 3.6V - Digital 1.62V to 2.0V 2-wire I2C and 3- or 4-wire SPI serial control interface Standard sample rates from 8kHz to 96kHz W-CSP, 3.6x3.9mm 49-pin APPLICATIONS Portable gaming, Voice recorders Mobile multimedia Stereo DSC-Camcorder |
Аналогичный номер детали - WM8962B |
|
Аналогичное описание - WM8962B |
|
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |
Russian ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
