Page 10/13

www.lem.com

HLSR-P series

HLSR-P series, Maximum continuous DC current

Important notice: whatever the usage and/or application, the transducer jumper temperature shall not go above the maximum

ratings of 120 °C as stated in page 2 of this datasheet.

Definition of typical, minimum and maximum values

Minimum and maximum values for specified limiting and safety conditions have to be understood as such as well as values shown

in “typical” graphs.

On the other hand, measured values are part of a statistical distribution that can be specified by an interval with upper and lower

limits and a probability for measured values to lie within this interval.

Unless otherwise stated (e.g. “100 % tested”), the LEM definition for such intervals designated with “min” and “max” is that the

probability for values of samples to lie in this interval is 99.73 %.

For a normal (Gaussian) distribution, this corresponds to an interval between -3 sigma and +3 sigma. If “typical” values are not

obviously mean or average values, those values are defined to delimit intervals with a probability of 68.27 %, corresponding to an

interval between -sigma and +sigma for a normal distribution.

Typical, maximal and minimal values are determined during the initial characterization of a product.

0

20

40

60

-40

-20

0

20

40

60

80

100

120

140

HLSR 10-P

HLSR 16-P

HLSR 20-P

HLSR 32-P

HLSR 40-P

HLSR 50-P