SGS4-F108P3PS1W00 | SLG

SWITCHING AUTOMATION LIGHT GRIDS

2016-03-09 17:40:10 | Online data sheet

Subject to change without notice

AUTOMATION LIGHT GRIDS | SICK

7

Invert second

switching output

Pushbutton lock

Invert switching

output

Q

ON

3

2

1

Q

ON

3

2

1

Press teach button > 5 s.

The light grid switches into the

configuration mode – menu item

“cross beam/parallel beam”.

The first green LED from top

flashes.

1. Light grid in RUN mode,

green LED “ON”

illuminates, yellow LED

“Q” illuminates.

The other menu items in sequence of the menu setting of the light grid

4. Exit the configuration

mode.

2. Cross or parallel beam

3. Go to the next menu item.

Press teach button for 1 s to 5 s

to switch to the next menu item

(in this case “alignment aid”).

oder

3 = Press teach button > 5 s,

save parameters.

4 = Wait > 30 s,

parameters not saved.

Func

Q

ON

3

2

1

> 5 s

< 1 s

1 = Yellow LED on,

“Crossed beam” active.

2 = Yellow LED off,

“Parallel beam” active.

Press teach button < 1 s to

switch between the settings.

Q

ON

3

2

1

1

3

Q

ON

3

2

1

2

4

1 s ... 5 s

> 5 s

> 30 s

active

Q

ON

3

2

1

inactive

Q

ON

3

2

1

Q

Q

ON

3

2

1

Q

Q

ON

3

2

1

active

inactive

Q

ON

3

2

1

Q

ON

3

2

1

AUTO

TEACH

AUTO

TEACH

active

inactive

Q

ON

3

2

1

Q

ON

3

2

1

active

inactive

Q

ON

3

2

1

Q

ON

3

2

1

active

inactive

Q

ON

3

2

1

Q

ON

3

2

1

Q

ON

3

2

1

Q2

Q2

MUTING

MUTING

Q

ON

3

2

1

If the teach button is pressed longer than 5 s, you switch into the configuration mode. In the configuration mode the menu items

are indicated by the green LEDs. If the teach button is then pressed for < 1 s, the respective function is activated or reset (yellow

LED on or off). If the teach button is pressed for 1 s to 5 s long, you switch to the next menu item. To exit the configuration mode,

press the teach button for > 5 s or wait for 30 s.

1)

Configure the light grid in a 3-way cross-beam or a parallel-oriented operating principle. The cross beam can be used to improve the resolution in the middle detection area. Objects up to a size

of 25 mm can be detected. The response time increases.

2)

The alignment aid is recommended for applications with high ranges. The signal strength of the receiver is permanently displayed by four green alignment LEDs. Depending on the strength,

the number of illuminated LEDs differ. When reception is strong, all four LEDs illuminate. The alignment aid must be deactivated again after alignment.

3)

After commissioning (power on), the switching threshold is taught in automatically. No object should be between the sender and receiver during this process.

4)

With standard values “active” all parameters are reset to the delivery state.

5)