How to reach us:

http://www.infineon.com

Published by

Infineon Technologies AG,

St.-Martin-Strasse 53,

81669 München

© Infineon Technologies AG 2002. All Rights Reserved.

Attention please!

The information herein is given to describe certain components

and shall not be considered as warranted characteristics.

Terms of delivery and rights to technical change reserved.

We hereby disclaim any and all warranties, including but not

limited to warranties of non-infringement, regarding circuits,

descriptions and charts stated herein.

Infineon Technologies is an approved CECC manufacturer.

Information

For further information on technology, delivery terms

and conditions and prices please contact your nearest

Infineon Technologies Office in Germany or our

Infineon Technologies Representatives worldwide.

Warnings

Due to technical requirements components may contain dan-

gerous substances. For information on the types in question

please contact your nearest Infineon Technologies Office.

Infineon Technologies Components may only be used in life-

support devices or systems with the express written approval

of Infineon Technologies, if a failure of such components can

reasonably be expected to cause the failure of that life-support

device or system, or to affect the safety or effectiveness of that

device or system. Life-support devices or systems are intend-

ed to be implanted in the human body, or to support and/or

maintain and sustain and/or protect human life. If they fail, it is

reasonable to assume that the health of the user or other

persons may be endangered.

Published by Infineon Technologies AG

Ordering No. B134-HXXX-X-X-7600

Printed in Germany

PS 12021.

NB

Hardware

PBA 313 02 is a long-range microwave frequency radio trans-

ceiver for Bluetooth communication links that are designed to

operate in the globally available unlicensed ISM frequency

band, 2.4–2.5 GHz.

Fast frequency hopping (1600 channel hops/s) with 79 chan-

nels (2.402 to 2.480 GHz) and a maximum TX & RX bit rate of

1 Mbit/s.

The implemented modulation technique is Gaussian Fre-

quency Shift Keying (GFSK) with a BT product of 0.5. The

channel bandwidth is 1 MHz and the frequency deviation is

between 140 and 175 kHz.

The Bluetooth Radio is built around a BiCMOS ASIC. Antenna

filter, RX and TX baluns are all integrated into the ceramic

carrier.

Operating from a 2.8 V supply voltage, the device has a typical

supply current requirement of only 60 mA (receive mode) or

150 mA (transmit mode), thus helping to extend battery life for

portable equipment.

A standby mode provides further power savings.

Control interface

Operating together with a Bluetooth Baseband using Bluetooth

Core from Ericsson is recommended.

Antenna interface

50 Ohm Bluetooth ISM band antenna (2.4-2.5 GHz).

Ordering information

The Bluetooth Radio from Infineon Technologies may be

ordered as: PBA 313 02/1.

Key data

Parameter

Min

Typ

Max

Unit

Frequency range

Reference clock frequency

Receiver sensitivity level

2.402

10

-86

2.480

20

GHz

MHz

dBm

Output power

Supply Voltage VCC

Supply Voltage VCC_PA

Maximum Temperature range

2.65

2.7

-30

17

2.8

3.2

20

3.0

5.5

+75

dB

V

V

°C