M95020-DWDW4TP datasheet(23/41 Pages) STMICROELECTRONICS

номер детали	M95020-DWDW4TP

подробное описание детали	Automotive 2-Kbit serial SPI bus EEPROMs

PDF	41 Pages

Scroll/Zoom	100%

производитель	STMICROELECTRONICS [STMicroelectronics]

домашняя страница	http://www.st.com

Logo

23 / 41 page

DocID025284 Rev 5

23/41

M95020-A125 M95020-A145

Instructions

Figure 14. Read Lock Status sequence

4.10

Lock Identification Page (LID)

The Lock Identification Page (LID) command is used to permanently lock the Identification

Page in Read-only mode.

The LID instruction is issued by driving Chip Select (S) low, sending (MSB first) the

instruction code, the address and a data byte on Serial Data input (D), and driving Chip

Select (S) high. In the address sent, A7 must be equal to 1. All other address bits are Don't

Care (it might be easier to define these bits as 0, as shown in Table 6). The data byte sent

must be equal to the binary value xxxx xx1x, where x = Don't Care. The LID instruction is

terminated by driving Chip Select (S) high at a data byte boundary, otherwise, the instruction

is not executed.

Figure 15. Lock ID sequence

Driving Chip Select (S) high at a byte boundary of the input data triggers the self-timed Write

cycle which duration is tW (specified in Table 14). The instruction sequence is shown in

Figure 15.

M95020-DWDW4TP датащи(PDF) 23 Page - STMicroelectronics