13

Copyright © 2015 Future Technology Devices International Limited

VM810C EVE2 CREDIT CARD MODULE

Version 1.1

Document No.: FT_001225 Clearance No.: FTDI#464

In this section it is assumed the 5V version of the MPSSE cable (FTDI part no C232HM-EDHSL-0) is used.

If the 3.3V version of the MPSSE cable (FTDI part no C232HM-DDHSL-0) is available, the setup is similar

except for the power pin connection which requires an additional 5V power source to connect to CN2 or

CN1. Refer to table 5-1 for board power configuration.

Figure 5-1 – VM810C connects to PC via VA800A-SPI or MPSSE cable.

Hardware Setup VA800A-SPI



Solder a 10 position single row pin header to J5 footprint of the VM810C board



Connect VA800A-SPI to the VM810C module in the correct orientation (pin1 to pin1 aligned).



Connect USB cable (e.g. FTDI accessory VA-FC-1M-BKW or VA-FC-1M-BLW) from the VA800A-SPI

to the PC USB host port.



VA800A-SPI will supply power to VM810C after MPSSE driver is properly loaded and the USB host

completed USB device configuration.

Hardware Setup MPSSE Cable



Solder a 10 position single row pin header to J5 footprint of the VM810C board



Connect MPSSE leads to VM810C board’s J5( SPI interface) in accordance with Table 5-2



Plug MPSSE cable to PC USB host port

Software Setup



Download PC based MPSSE software libraries. MPSSE cable and driver information can be found at

http://www.ftdichip.com/Products/Cables/USBMPSSE.htm.



Launch the Sample Application based on MPSSE from the PC