| поискавой системы для электроныых деталей |
|
RN131 датащи(PDF) 27 Page - Microchip Technology |
|
|
|||||||||||||||||||||||||||||
RN131 датащи(HTML) 27 Page - Microchip Technology |
|
27 / 40 page ![]() RN131/RN171/RN1723 EVALUATION KITS USER’S GUIDE 2013-2015 Microchip Technology Inc. DS50002183B-page 27 Chapter 3. Application Design Concerns This section provides the design concerns related to powering an evaluation board, sensor interface settings, AP mode, and restoring factory settings. The following topics are discussed: • Sensor Interfaces • Push Button Functions 3.1 SENSOR INTERFACES The input voltage on the sensor inputs must not exceed 1.2V; otherwise, hardware damage could occur. The Analog-to-Digital Converter (ADC) saturates at 400 mV. It is recommended to use the sensor power output to drive any analog devices that are attached to the sensor pins. 3.2 PUSH BUTTON FUNCTIONS 3.2.1 FN Push Button The FN push button can be used to place the RN module into one of three modes: AP, Factory reset, and WPS. 3.2.1.1 AP MODE AP mode allows all Wi-Fi-enabled devices to be associated with the RN module. To put the RN module into AP mode, FN must be high when the RN module powers up or wakes from a sleep state. This is done by pressing the FN push button, and then pressing and releasing the RESET/RST push button, which resets the RN module and places it into AP mode. Now that the RN module is in AP mode, a default Wi-Fi network is created with the parameters listed in Table 3-1. TABLE 3-1: AP MODE DEFAULT SETTINGS Once the RN module boots, other Wi-Fi-enabled devices will be able to locate the RN module whenever scanning for access points. Note: Sensor pins 2 and 3 have a resistor network in front of sensors 4 and 5, respectively. Therefore, these pins can be driven with up to 3.3V DC. Note: Using this method to place the RN module into AP mode will override any previous AP mode software settings. Setting AP Mode Default SSID WiFly-xxx-yy Where ‘xxx’ is GSX for RN131, EZX for RN171, and FZX for RN1723 and ‘yy’ is the LSB of the module’s MAC address. Channel 1 DHCP Server Enabled IP Address 192.168.1.1 Netmask 255.255.255.0 Gateway 192.168.1.1 |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |