8

A165E

Installation

Mounting to the Panel (Models with Separate Construction)

After installing the Operation Unit, snap in the Switch from the back of the panel.

(1) Installing the Operation Unit

(2) Mounting the Switch

(3) Removing the Switch

• Snap on the Switch to the Operation Unit.

• Make sure that the Switch has the correct orientation when snapping it onto the

Operation Unit.

• Align the white dot on the Operation Unit with the guide groove on the side of

the Switch marked with an “L” as shown below, and push the Switch into the

Operation Unit until it clicks into place. Confirm that the Switch is securely in

place before using.

• Insert the prongs of the A16Z-5080 Extractor between the Switch and the

Operation Unit, grip the Switch, and pull to remove.

(4) Installing the LED Lamp

• When mounting the Lamp, make sure it is facing the direction shown in the

following diagram. Insert the Lamp while matching the protruding part of the

Lamp and the small guides on the outer surface of the switch.

Panel

Mounting nut

Lock ring (included

with the product)

Rubber packing (included with the product)

or Yellow Plate (sold separately)

Edge

Lock

Cutout

Panel

Mounting nut (included

with the product)

Lock hole

Lock ring (included

with the product)

Rubber packing

(included with the

product) or Yellow

Plate (sold separately)

• Attach rubber packing or the

Yellow Plate onto the Operation

Unit from its terminal side. Insert

the Operation Unit into the panel

from the front. Install the lock ring

and mounting nut from the

terminal side and tighten.

• Adjust the slits on the hole of

rubber packing and Yellow Plate

to the protruding part of the Unit.

• Rubber packing is not necessary

when the Yellow Plate is used.

• Tighten the nut to the torque of

0.29 to 0.49 N·m.

• The Operation Unit should be

installed with its

protruding part adjusted to the slit

of the panel hole.

• Align the lock ring to the groove of

the Operation Unit so that the

edge is drawn to the panel side.

White dot

Guide groove

L marking

Extractor (A16Z-5080)

Narrow guide

Protruding part

Wide guide