DVC500 Series

D C / D C A U T O M O T I V E C O N V E R T E R

FEATURES

• 500W Automotive and Vehicle Converter

• Designed for use in rough environment

• Rugged construction / potted device

• Protection against unfavourable environmental conditions

• DC/DC wide range input

• Filtered against vehicle on-board disturbances

• Galvanic separation 1.5kV

• Design acc. to EN60950. EN50155. EN1175. ISO20898

• Regulated output

• Very high efficiency

• Short-circuit / No-load protection

• Over Temperature protection

• Parallel connectable (Option: Smart output characteristics)

SPECIFICATIONS

Doc. No. DVC500 Rev.D 25-11-15

www.powerbox.com.au - 1800 251 380

www.powerbox.co.nz - 0800 104 480

INPUT

Input voltage

36V, 48V, 72V, 96V, 110V

Input range

See selection table

Filtering

Filtering against on board disturbances

OUTPUT

Output voltage

12.5Vdc, 13.8Vdc, 24.3Vdc

Output Voltage Tolerance

+/- 1%

Output Current

See Selection Table

Current Limiting

Typically 1.1 x I nominal

Load Regulation

+/-0.5% (Typ 0.3% = 80mV) 10-90% load

Regulation time

<1 ms

Line regulation

±0.1%

Temperature drift

-25C to +70C <1%

Ripple & noise

100mVp-p

Efficiency

92% Typical

Parallel Operation

Unlimited, 100% redundancy

requires external diodes

ENVIRONMENT

Ambient temperature

-40°C to 75°C with derating,

Max baseplate temperature 100°C

Storage temperature

-40°C to 85°C

Humidity

100% relative humidity, dewing permitted.

Cooling

Natural convection / cooling

via contact to mounting surface.

STANDARDS & APPROVALS

Safety

EN60950, EN50155, EN1175, ISO20898

EMC

EN61204-3

PROTECTION

Protective degree

IP67 (not connector)

Reverse polarity Protection

External input fuse is blown.

Over temperature Protection

Protective shut down, self reset after cool down.

Insulation

Input to Output: 1.5kV

Input to Case: 1.5kV

Ouput to Case: 500V

Over voltage Protection

Protective shut down

Self reset after cool down.

Safety Note

If an external energy source (e.g battery) is

connected to the output of the converter, the

supply line (+pole)must be fused close by the

source. Recommended fusing: 1.1.. 1.2 x Inom

MECHANICAL

Connectors

Input: +Uin (M5) / -Uin(M8)

Output: +Uout (M6) / -Uout(M8)

Dimensions

222(220) x 166(122) x 71(47)mm

Weight

2.65Kg

Case Material

Aluminium