53124 datasheet(4/13 Pages) MICROPAC

4 / 13 page

Micropac Industries cannot assume any responsibility for any circuits shown or represent that they are free from patent infringement.

Micropac reserves the right to make changes at any time in order to improve design and to supply the best product possible.

MICROPAC INDUSTRIES, INC. HYBRID MICROELECTRONICS PRODUCTS DIVISION

• 905 E. Walnut St., Garland, TX 75040 • (972) 272-3571 • Fax (972) 494-2281

www.micropac.com

E-MAIL: hybridsales@micropac.com

02/15/01

53124

Radiation Tolerant Power MOSFET Optocoupler

___________________________________________________________________________________________

TYPICAL CHARACTERISTICS - (Pre-Irradiation)

All typical values are at TA = 25°C, IF (ON) = 10 mA, VF (OFF) = 0.6 V unless otherwise specified.

Parameter

Symbol

Test Conditions

Typical Value

Units

Notes

Output Off-Capacitance

CO (OFF)

VO = 28 V

f = 1 MHz

145

Output Offset Voltage

VOS

IF = 10 mA

IO = 0 mA

µV

Input Diode Temperature Coefficient

∆VF /∆TA

IF = 10 mA

-1.4

mV/°C

Input Capacitance

CIN

VF = 0 V

f = 1 MHz

Input-Output Capacitance

CI-O

VI-O = 0 V

f = 1 MHz

1.5

Input-Output Resistance

RI-O

VI-O = 500 V

t = 60 s

Ω

Notes:

1. Maximum average current rating where the case temperature (TC) is maintained below 120°C.

2. Maximum junction to case thermal resistance for the device is 15°C/W, where case temperature (TC) is

measured at the center of the package bottom.

3. For rating, see Figure 5. The output power PD rating curve is obtained when the part is handling the maximum

average output current IO as shown in Figure 3.

4. During the pulsed RON measurement (IO duration < 30 ms), ambient (TA) and case temperature (TC) are equal.

5. Pins 2 through 3 shorted together and pins 5 through 8 shorted together.

6. This is a momentary withstand test, not an operating condition.

7. VOS is a function of IF and is defined between pins 5 and 8, with pin 5 as the reference. VOS must be measured

in a stable ambient (free of temperature gradients).

8. Zero-bias capacitance measured between the LED anode and cathode.

CAUTION:

Care should be taken not to exceed the maximum output power dissipation, maximum case temperature, and

maximum junction temperature when repetitively switching loads.

53124 датащи(PDF) 4 Page - Micropac Industries

53124 датащи(HTML) 4 Page - Micropac Industries

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13

датащи скачать

ссылки URL