2

DC =

=

1.3 x 10

ON

LM34910C

SNVS517B – MAY 2007 – REVISED MARCH 2013

www.ti.com

Functional Description

The LM34910C Step Down Switching Regulator features all the functions needed to implement a low cost,

efficient buck bias power converter capable of supplying 1.25A to the load. This high voltage regulator contains a

55V N-Channel buck switch, is easy to implement, and is available in the thermally enhanced WSON-10

package. The regulator’s operation is based on a hysteretic control scheme, and uses an on-time control which

input voltage variations. The hysteretic control requires no loop compensation resulting in very fast load transient

response. The valley current limit detection circuit, internally set at 1.25A, holds the buck switch off until the high

current level subsides. The functional block diagram is shown in Typical Application Circuit and Block Diagram.

The LM34910C can be applied in numerous applications to efficiently regulate down higher voltages. Additional

duty cycle limiter.

Hysteretic Control Circuit Overview

The LM34910C buck DC-DC regulator employs a control scheme based on a comparator and a one-shot on-

timer, with the output voltage feedback (FB) compared to an internal reference (2.5V). If the FB voltage is below

the reference the buck switch is turned on for a time period determined by the input voltage and a programming

falls below the reference. The buck switch then turns on for another on-time period. Typically, during start-up, or

when the load current increases suddenly, the off-times are at the minimum of 280 ns. Once regulation is

established, the off-times are longer.

When in regulation, the LM34910C operates in continuous conduction mode at heavy load currents and

discontinuous conduction mode at light load currents. In continuous conduction mode current always flows

through the inductor, never reaching zero during the off-time. In this mode the operating frequency remains

relatively constant with load and line variations. The minimum load current for continuous conduction mode is

one-half the inductor’s ripple current amplitude. The operating frequency is approximately:

(1)

The buck switch duty cycle is equal to :

(2)

In discontinuous conduction mode current through the inductor ramps up from zero to a peak during the on-time,

then ramps back to zero before the end of the off-time. The next on-time period starts when the voltage at FB

falls below the reference - until then the inductor current remains zero, and the load current is supplied by the

output capacitor (C2). In this mode the operating frequency is lower than in continuous conduction mode, and

varies with load current. Conversion efficiency is maintained at light loads since the switching losses reduce with

the reduction in load and frequency. The approximate discontinuous operating frequency can be calculated as

follows:

where

•

(3)

The output voltage is set by two external resistors (R1, R2). The regulated output voltage is calculated as

follows:

(4)

6

Submit Documentation Feedback

Copyright © 2007–2013, Texas Instruments Incorporated

Product Folder Links: LM34910C