+

-

+

-

SS:0.55V

OP:2V

0.45V

high clamp

low clamp

COMPx

LP3873, LP3876

www.ti.com

SNVS220E – NOVEMBER 2002 – REVISED APRIL 2013

Figure 23. Error Flag Operation

SENSE PIN

In applications where the regulator output is not very close to the load, LP3876 can provide better remote load

regulation using the SENSE pin. Figure 24 depicts the advantage of the SENSE option. LP3873 regulates the

voltage at the output pin. Hence, the voltage at the remote load will be the regulator output voltage minus the

drop across the trace resistance. For example, in the case of a 3.3V output, if the trace resistance is 100m

Ω, the

sense pin. Connecting the sense pin to the remote load will provide regulation at the remote load, as shown in

Figure 24. Improving remote load regulation using LP3876

SHUTDOWN OPERATION

A CMOS Logic level signal at the shutdown ( SD) pin will turn-off the regulator. Pin SD must be actively

terminated through a 10k

Ω pull-up resistor for a proper operation. If this pin is driven from a source that actively

pulls high and low (such as a CMOS rail to rail comparator), the pull-up resistor is not required. This pin must be

tied to Vin if not used.

DROPOUT VOLTAGE

The dropout voltage of a regulator is defined as the minimum input-to-output differential required to stay within

2% of the nominal output voltage. For CMOS LDOs, the dropout voltage is the product of the load current and

the Rds(on) of the internal MOSFET.

Copyright © 2002–2013, Texas Instruments Incorporated

Submit Documentation Feedback

13

Product Folder Links: LP3873 LP3876