_______________Detailed Description

The MAX774/MAX775/MAX776 are negative-output,

inverting power controllers that can be configured to drive

an external P-channel MOSFET. The output voltages are

preset to -5V (MAX774), -12V (MAX775), or -15V

(MAX776). Additionally, all three parts can be set to any

desired output voltage using an external resistor divider.

The MAX774/MAX775/MAX776 have a unique control

scheme (Figure 1) that combines the advantage of

pulse-skipping, pulse-frequency-modulation (PFM)

converters (ultra-low supply current) with the advan-

tage of pulse-width-modulation (PWM) converters (high

efficiency with heavy loads). This control scheme

allows the devices to achieve 85% efficiency with loads

from 5mA to 1A.

As with traditional PFM converters, the external

P-channel MOSFET power transistor is turned on when

the voltage comparator senses that the output is below

the reference voltage. However, unlike traditional PFM

converters, switching is controlled by the combination

on-time/off-time limits set by one-shots. Once turned

on, the MOSFET stays on until:

1) the 16µs maximum on-time limit is reached

or

2) the switch current reaches its limit (as set by the

current-sense resistor).

Once off, the switch is typically held off for a minimum of

2.3µs. It will stay off until the output drops below the level

-5V/-12V/-15V or Adjustable,

_______________________________________________________________________________________

9

N

1.5V

REFERENCE

Q

TRIG

ONE-SHOT

Q

TRIG

ONE-SHOT

CURRENT

CONTROL CIRCUITS

MODE

COMPARATOR

ERROR

COMPARATOR

CURRENT

COMPARATOR

FROM V+

FROM OUT

0.2V

(FULL

CURRENT)

0.1V

(HALF

CURRENT)

FROM

V+

MAX774

MAX775

MAX776

REF

V+

SHDN

FB

OUT

CS

EXT

GND

S

R

Q

50mV

Figure 1. Block Diagram