Specifications subject to change without notice.

Thomas Research Products • 1215 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com

TWR-PI Plug-in Wireless Relay

ZenNet Wireless Lighting On/Off Plug-in Switch Module

5 year Warranty

Specifications

Power Supply

120Vac, 50/60Hz

Maximum Load

• General Purpose – 15A @ 120Vac

• Resistive – 15A @ 120Vac

• Tungsten – 960W @ 120Vac

• Ballast – 600W @ 120Vac

• Motor Load Rating – ½ HP @ 120Vac

Power Consumption

1.1W @ full load, 500mW quiescent

Inputs/Outputs

• Standard male plug for power input

• Standard female plug for controlled output

• 1 normally open relay

• Input for accessory tabletop rocker pad

• Radio Frequency (RF) transceiver

• 2 Buttons with LEDs -- configuration & manual control

RF Communications

EnOcean 902 MHz

Transmission Range

80ft (25m)

Dimensions

4.09”H x 1.85”W x 1.26”D (103.9mm x 47mm x 32mm)

Weight

12.3oz. (348g

Cord Lengths

Plug cord: 3ft. (91.4cm)

Outlet cord: 1 ft. (30.5cm)

Mounting

Free standing, or mounts to wall using

included mounting plate

Environment

• Indoor use only

• 32° to 131° F (0° to 55° C)

• 20% to 95% relative humidity (non-condensing)

Interoperable Products

(EnOcean Profiles)

• Rocker Pad Switch (F6-02-02)

• Key Card Switch (F6-04-01)

• Window handle (F6-10-00)

• 1BS Single Input Contact (D5-00-01)

• Temperature Sensor, 0° to 40° C (A5-02-05)

• Occupancy Sensor (A5-07-01)

• Contact, single input (A5-30-01)

• Central Gateway (A5-38-08)

ZenNet Wireless Lighting Controls

Part Number

Description

TWR-PI-W

White 2 button Fixture Control Module

Agency Compliance

UL/CUL

UL244A, UL1472

CSA

22.2 No. 184

FCC

SZV-STM300U

IC

5713A-STM300U

ZenNet Plug-In Relay Module provides simple wireless solution for

lighting control through any standard outlet. The module uses ultra

low power radio frequency technology to communicate wirelessly.

Simply plug the module into any standard outlet and then plug the

lamp into the receptacle on the opposite end. Link the module to a

ZenNet switch or occupancy sensor for convenient wireless control.

• Provides switching of plug-in electrical loads

• Plugs into any standard outlet, no wiring required

• Two molded buttons with LED indicator lights can be used to

configure or manually control the device.

• Easily links with wireless rocker pads or sensors

Dimensions (Nom.)

104mm

4.09”

47mm

1.85”

30mm

1.18”

1’ Cord to

Receptacle End

3’ Cord to Plug End

Set (I) Button

Menu (O) Button

Rev 7-8-15