MAX4613CSLASHD datasheet(4/8 Pages) MAXIM

4 / 8 page

Quad, SPST Analog Switch

_______________________________________________________________________________________

ELECTRICAL CHARACTERISTICS—Single Supply (continued)

(V+ = 12V, V- = 0, VL = 5V, GND = 0V, VINH = 2.4V, VINL = 0.8V, TA = TMIN to TMAX, unless otherwise noted.)

Note 2: Typical values are for design aid only, are not guaranteed and are not subject to production testing. The algebraic convention,

where the most negative value is a minimum and the most positive value a maximum, is used in this data sheet.

Note 3: Guaranteed by design.

Note 4: On-resistance match between channels and flatness are guaranteed only with bipolar-supply operation. Flatness is defined

as the difference between the maximum and the minimum value of on-resistance as measured at the extremes of the speci-

fied analog signal range.

Note 5: Leakage parameters IS(OFF), ID(OFF), ID(ON), and IS(ON) are 100% tested at the maximum rated hot temperature and guaranteed at +25°C.

Note 6: Off-Isolation Rejection Ratio = 20log (VD/VS).

Note 7: Between any two switches.

__________________________________________Typical Operating Characteristics

(TA = +25°C, unless otherwise noted.)

-2

-1

-15

VS, VD (V)

TA = +125°C

TA = +85°C

V+ = 15V

V- = -15V

-10

-5

ON LEAKAGE CURRENTS

-1

-0.5

0.5

VS, VD (V)

-15

-10

-5

TA = +125°C

V+ = 15V

V- = -15V

TA = +85°C

OFF LEAKAGE CURRENTS

0.5

1.5

2.0

2.5

3.0

3.5

±5

±10

±15

±20

BIPOLAR SUPPLY VOLTAGE (V)

IN LOW MAX

SWITCHING THRESHOLD vs.

BIPOLAR SUPPLY VOLTAGE

IN HIGH MIN

100

125

VD (V)

V+ = 10V

V+ = 15V

V+ = 20V

150

V+ = 5V

ON-RESISTANCE vs. VD

(UNIPOLAR SUPPLY VOLTAGE)

120

-20

-10

VD (V)

ON-RESISTANCE vs. VD

(BIPOLAR SUPPLY VOLTAGE)

V± = ±5V

V± = ±10V

V± = ±15V

V± = ±20V

100

VD (V)

TA = +125°C

TA = -55°C

TA = +25°C

V+ = 15V, V- = -15V

-15

-10

-5

ON-RESISTANCE vs. VD (BIPOLAR

SUPPLY VOLTAGE AND TEMPERATURE)

PARAMETER

SYMBOL

MIN

TYP

MAX

(Note 2)

UNITS

TA = +25°C

300

400

VS = 8V, Figure 2

TA = +25°C

tON

Turn-On Time (Note 3)

TA = +25°C

200

VS = 8V, Figure 2

tOFF

Turn-Off Time (Note 3)

CL = 1nF, VGEN = 0,

RGEN = 0, Figure 4

Charge Injection (Note 3)

CONDITIONS

DYNAMIC

MAX4613C/D датащи(PDF) 4 Page - Maxim Integrated Products

MAX4613C/D датащи(HTML) 4 Page - Maxim Integrated Products

Html Pages

1 2 3 4 5 6 7 8

датащи скачать

ссылки URL