LP6250 datasheet(6/8 Pages) POWER

6 / 8 page

Preliminary Datasheet

LP6250

LP6250 –00 Version 1.0 Datasheet

Sep.-2010

www.lowpowersemi.com

Page 6 of 8

Operation Information

Output Voltage

The error amplifier compares a sample of the dc-dc

converter output voltage with the 0.5V (VREF)

reference and generates an error signal for the PWM

comparator. Output voltage of dc-dc converter is

setting with the resistor divider by the following

equation:

Vout=(R1/R2+1) X 0.5V

Oscillator

The switching frequency of LP6250 up to operate at

either 500KHz.

Soft Start

The soft start is functional after power on. The

interval of soft start time is determined by a

capacitor connected to SS pin. When EN pin is

taken high, the soft start capacitor (CSS) is charged

by a constant current of 4μA (typ.). During this

interval, the SS voltage directly controls the peak

inductor current. The maximum load current is

available after the soft-start interval is completed.

Once the EN pin is taken low, the soft-start

capacitor is discharged to ground to prepare for next

start-up.

The load must wait for the soft-start interval to

finish before drawing a significant amount of load

current. The duration after which the load can begin

to draw maximum load current is:

The LP6250 can be turn off to reduce the supply

current to 0.1μA when EN is low. In this mode, the

internal reference, error amplifier, comparators, and

biasing circuitry turn off while the N-channel

MOSFET is turned off. The boost converter’s

output is connected to VCC by the external inductor

and catch diode.

Output Current Capability

The output current capability of the LP6250 is a

function of current limit, input voltage, operation

frequency, and inductor value. Because of the slope

compensation used to stabilize the feedback loop,

the duty cycle affects the current limit. The output

current capability is governed by the following

equation:

Current Limitation

The internal power-MOS switch current is

monitored cycle-by-cycle and is limited to the value

not exceed 2.1A (Typ.). When the switch current

reaches the limited value, the internal power-MOS

is turned off immediately until the next cycle.

Low Battery Detector

The LP6250 provides an on-chip comparator with

35mV internal hysteresis for low battery detection.If

the LBI pin voltage falls below the internal

reference voltage(0.5V),the LBO pin(an open-drain

output) sinks current to GND.The LBI pin should be

connected to BAT pin if the low battery comparator

is not used.

Layout considerations

Typical for all switching power supplies, the

layout is an important step in the design;

especially

high

peak-currents

and

switching frequencies. If the layout is not

carefully done, the regulator might show

noise problem sand duty cycle fitter. The

input capacitor should be placed as close as

possible to the input pin for good input

voltage viltering. The inductor and diode

should be placed as close as possible to the

switch pin to minimize the noise coupling in

to other circuits. Since the feedback pin and

network is a high impedance circuit the

feedback network should be routed away

from the inductor. The feedback pin and

feedback network should be shielded with a

ground plane or trace to minimize noise

coupling into this circuit.

LP6250 датащи(PDF) 6 Page - Lowpower Semiconductor inc

LP6250 датащи(HTML) 6 Page - Lowpower Semiconductor inc

Html Pages

1 2 3 4 5 6 7 8

датащи скачать

ссылки URL