AN3209 datasheet(24/42 Pages) STMICROELECTRONICS

24 / 42 page

Developing, compiling and debugging your datalogger firmware

AN3209

24/42

Doc ID 17419 Rev 2

Developing, compiling and debugging your

datalogger firmware

4.1

Installing the datalogger application firmware

The source code of the demonstration M24LR64-R_Datalogger_application_firmware is

then available under C:\Program Files\M24LR64-

R_Datalogger_Application\sources\M24LR64-R_Datalogger_application_firmware

(see Figure 16) or by clicking Start > M24LR64-R_Datalogger_Application > M24LR64-

R_Datalogger_application_firmware.

4.2

Software tool-chain overview

To develop, compile and run an application software on an STM8L101K3 microcontroller,

the following software tool-chain components are required (see Figure 18):

●

Integrated development environment (IDE) composed of the ST Visual Develop

(STDV) and the ST Visual programmer software interface (STVP).

●

A C complier

●

The R-LINK hardware

Figure 18.

Needed material to compile and run an application on STM8L101K3

4.2.1

ST Visual Develop (STDV)

STVD is a full-featured development environment. It is a seamless integration of the Cosmic

and Raisonance C compilers for STM8 microcontroller family. STDV software is available

from http://www.st.com.

To install STDV, download the installation software and follow each step of the installation

wizard. When the installation is complete, the executable is available under

START>Programs>ST Toolset > Development Tools> ST Visual Develop.

4.2.2

C compilers

The C compilers are integrated into the STDV development environment. They allow to

directly configure and control the building of your application through an easy-to-use

graphical interface. The demonstration application uses STM8 Cosmic C compiler (free

version up to 16 KBytes of code).

AN3209 датащи(PDF) 24 Page - STMicroelectronics