UPD6461GS datasheet(39/60 Pages) NEC

39 / 60 page

µPD6461, 6462

4.4 CONTINUOUS INPUT OF COMMAND

Transfer each of the 1-byte, 2-byte, and 2-byte successive commands from a microcontroller to the

µPD6461, 6462

as follows.

To transfer a 1-byte or 2-byte command, or a 2-byte successive command with blinking data changed after a 2-

byte successive command has been transferred, either make CS high once, or transfer 2-byte successive command

end code (FFH:

µPD6461/7FH: µPD6462) at the end of the 2-byte successive command. In the latter case, it is not

necessary to make CS high.

4.4.1 When End Code is Not Used

Example 1-byte command

→ 2-byte successive command → 1-byte command

DATA

CLK

Make CS low once and then back high again.

2nd byte

(D0-D7)

MSB first (LSB first)

2nd byte

(D8-D15)

00H-FEH ( PD6461)

00H-7EH ( PD6462)

(normal character)

2-byte successive

command

1st byte

(D0-D7)

1-byte command

(D0-D7)

(D8-D15)

00H-FEH ( PD6461)

00H-7EH ( PD6462)

(normal character)

D7-D0

D15-D8

D7-D0

1-byte command

4.4.2 When End Code is Used

Example 1-byte command

→ 2-byte successive command → 1-byte command

DATA

CLK

1-byte command

2nd byte

(D0-D7)

MSB first (LSB first)

2nd byte

(D8-D15)

00H-FEH ( PD6461)

00H-7EH ( PD6462)

(normal character)

2-byte successive

command

1st byte

(D0-D7)

1-byte command

(D0-D7)

(D8-D15)

FFH ( PD6461)/

7FH ( PD6462)

(2-byte successive

command end code)

D7-D0

D15-D8

D7-D0

It is not necessary to make CS low and then back high again.

Remark By using the 2-byte successive command end code, the CS pin may remain low. However, it is

recommended to make CS pin high to improve the noise immunity.

UPD6461GS датащи(PDF) 39 Page - NEC

UPD6461GS датащи(HTML) 39 Page - NEC

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

датащи скачать

ссылки URL